7/30/2019 ALFO Indonesia

1/2

ALFO SYSTEM VERSION 01.06.02

UPGRADING PROCEDURE

1. PRELIMINARY

Start installed SCT program

Connect to Alfo

2. SOFTWARE DOWNLOAD

Select Equipment Version window

Click on Download SW Setup

In Download type mark Forced and Bench switch

In Download file path select this dwl file: 010602_lclfe1.dwl Click on Start and confirm by clicking on Proceed to download button. Bench status will

become Downloading

At download end, a result banner will appear

Wait for Alfo restart and Sct reconnection

Check new loaded software version by re-opening Equipment Version window

Software Version 010602 (LC-LF-E1)

FW Boot

FW Appl

FPGA 0FPGA 1

E82089 010012 or 010011

N90538 010402

Not presentN90560 000200

3. CONFIGURATION AND ALARMS UPDATING

After upgrading will appear Unit Sw Mismatch Alarm because Alfo is without PPP

configuration. In order to remove this alarm is needed to install SCT 4.5.2 (or successive)

otherwise is possible to remove alarm using a WEB browser (Internet Explorer, Mozilla)

3.1 CONFIGURATION AND ALARMS UPDATING WITH SCT 4.5.2 (or successive)

Click on Equipment-Communication SetUp Port Configuration

Select 2Mb EOC tab

Set the wished configuration or a default one (No 2Mb used means ALFO without PPP)

Unit Sw Mismatch Alarm should disappear

Click on Equipment-Alarm Severity Config

Set Properties of new alarm Tru SW RadioEquipment2MbEocLinkAlarm (This is the

alarm used to show a PPP protocol connection fail, normally is Warning-Trap on)

7/30/2019 ALFO Indonesia

2/2

3.2 CONFIGURATION AND ALARMS UPDATING WITH WEB-BROWSER

Disconnect SCT from unit (if connected)

Connect to unit using WEB browser: insert on Address line Http://

Login page will appear: insert password siaemicr and click Login button

If login is accepted, 3 frames will appear:

A main frame on the center-right of the screen (to view status and set parameters)

An option list frame on the left (to select option and view related main frame)

An alarm summary frame on the high-left (to view current alarms/operations summary)

On the list frame, select CONFIGURATION E1 settings

On the main frame, change E1 Network configuration, or confirm the default one, clicking on

related Apply button

On the list frame, select CONFIGURATION Alarm settings

On the main frame, scroll alarms to find E1 Eoc link alarm

Select this alarm clicking on related check box

Change alarm properties (from Disabled to sev. Warning-trap On) and then click on related

Apply button