2 wire speed sensor - headwindsolutions.ca
Post on 07-Dec-2021
3 Views
Preview:
TRANSCRIPT
Installation Instructions 2 WIRE SPEED SENSOR
Step1
Drill and tap into bell housing directly over top of the ring gear if there isn’t a hole already available.
Step 2
Thread magnetic sensor in until it touches the ring gear, then back off 1/2 - 3/4 turn and then tighten jam nut.
Step 3
Wiring of speed sensor Run one wire from the speed sensor to the RPM terminal in the rev limiter box. Run the other wire from the speed sensor to the ground location. As the two wire speed sensor is a non-polarized AC sensor, either wire can be run to the RPM terminal and/or ground.
©2018 Headwind Solutions. All rights reserved. 1-844-304-7277
www.headwindsolutions.ca V1.01/17 May 2018
top related