3660 - officeteamportal.co.uk · power requirement 1. input voltage level: 220-240v 50hz minimum...
Post on 23-Jul-2020
6 Views
Preview:
TRANSCRIPT
. ..
DIotec.,
" / 3660 O~L~
- -36613665
3665G4
Health & SafetyData Sheets
- -- - --------
Safety Data SheetCommercial Product Name: INFOTEC TONER:
3660/3661/3665/3665G4CA_RTRIDGECHEMICAL FORMULAIngredientsStyrene Acrylic PolymerPolyester ResinPolyoleiineIron OxideDye
2.8
.'.Janka UKPLC.StirlingWayBorehamwoodHerts.WD6 2AE
Tel: 01812072700Fax: 01819535403
Cas No.25038-19-5Not Known8003-07 -01317-81-931714-55-3
Physical DataMelting/Softening Point Not ApplicableBoiling Point Not ApplicableSpecific GravitypH Not ApplicableSolubility in water
°C°C
1.0°C(at gIl water)soluble(gIl) miscible
200C 0 0
liquid
o
'glml
Storage stability and handling
Special precautions for transportand storage
Ref No: EI07
% Contents25%20%
3%50%
2%
insoluble.gaseous
o
Not subject to any transport or storage regulations
Incompatible substances None
Hazardous decomposition products Cabon monixide and other decomposition productsin the case of incomplete combustionNoneHazardous reactions
Preventative measures Not required under normal conditions of use
Protective measuresNot required under normal conditions of use
o respiratorso gloveso goggles
Technical protective measuresNot required under normal conditions of use
Measures after spillageIf spilled sweep up or remove using a vacuum cleaner ratedfor toner extraction
DisposalCan be deposited with household rubbish, local authorityregulations must be observed
r-)" I;~INVESTOR IN PEOPLE
I!qistmd 0f1i0e:WharfHouso. The Wharf.Newbury,I!erb/JR RGU 5AP.1!qistmd in Fngbod No. 2199112
---
1.1.11.21.31.41.5
I. ':::;:.:: ..", '0"
!::;:
. 1.6
1.7
1.8
1.9-2.
2.1
2.2
2.3
2.4
2.4.1
2.5
2.6
2.7
Appearance & Odour BlackPowderwith slight plastic odour
Physical form ( 200C) solid paste. 0Vapour pressure (200C) Not Applicable
Density ( 2QoC) Not Applicable
'Commercial Product Name INFOTEC TONER:3660/36611366S1366SG4CARTRIDGE
3. Fire and explosion hazard
3.1. Flash point Not Apllicable oac, method of determination:
3.2 Ignition temp. Not Applicable oac, method of determination:
3.3. Extinguishing media . water mist. foam,
. C02. dry powder
tt
3.4.3.5
Special fire precautionsSpecial fire and explosion hazard
NoneNone
4. Information on toxicityOral toxicity:Dermal Compatibility:Ames Test
Greater than 5g1k.gbodyweightNon irritantNegative
5. Emergency and first-aid procedures
SkinEyesIngestion
: Wash offwith soap and water: Flush with water, if this is not possible consult doctor: Substantially non-toxic but if swallowed consult doctor
6. Information on ecology.j)'.,..-;0
.
",,:.4.
Has not been assessed
7. Special information
This information is based on our present state ofk:nowledge and is intended to describe our productsfrom the point of view of the safety requirements. It should not therefore be ,construed as guarantee-ing specific properties. ',.
~
Issue Date: December 1993 Issue No: 2
- --
Product data sheet Ref.No: T/05
Machine Type FACSIMILE 3660/3661/3665/3665G4
Electrical Safety StandardsType Tested and Approved
To EN 60950
Radio InterferenceType Tested and Approved
To VDE 0878
BABT Approvaol Number 3660
3661
NS/137113/N/602877 3665
NS/1371/3/P/604195 3665G4NS137113/N/603501
NS137113/N/603500
Ozone Emission
~itions of Measurement Testing was carried out in a sealed room and airsamples taken at the operators head level.Dylec ozone monitor 100 GAHJ
U L .Method32.8m38 Hours continuousNone22-32°C40-60%
Measurement EquipmentMeasurement MethodRoom SizeMachine OperationVentilationTemperatureHumidity
Results ofMeasurementOperators Breathing Area Average 0.018 ppm
EvaluationThe above results are below the recommended limit for ozone: 0.1 PPM
(8 Hour TWA Value)
Noise LevelMeasurementMachine in Operation
At 1 metre distance from machine<70 db (A)
Heat Output Transmission 26Reception 103Copying 138Standby 18
KCalIHKCal/HKCalIHKCalIH
:~:~Danka UKPLCStirlingWayBorehamwoodHerts.WD62AETel:01812072700Fax:01819535403
RogisIered Oftia:: Wharf !louse.The Wharf. Newbury, BerIcsIIireRG14SAP.RqisIa<d ia EngIaodNo. 2199112- -- -- -- - --
Recommended Enviromental Requirements
1. Temperature Range: 17°C to 28°C2. Humidity Range: 40% to 70% RH3. Ambient illumination: Less than 1,500 lux (Do not expose to direct sunlight).4. Ventilation: Room air should turn over at least 3 times/hour
or 30 cbmlhour per person5. Ambient Dust: Less than 0.15 mglm3(4 x 10-3oz!yd3)6. Room Size: More than 10m3(13.4 yd3)7. If the installation place is air-conditioned or heated, place the machine:
a. Where it will not be subjected to sudden temperature changes.b. Where ~twill not be directly exposed to cool air from an air conditioner in the
summer.c. Where it will not be directly exposed to reflected heat from a space heater in
winter.8. Avoid placing the fax in an area filled with corrosive gas.9. Avoid any area higher than 2,000 meters (6,500 ft) above sea level.10. Place the fax on a strong and level base.11. Avoid any area where the fax may be subjected to frequent strong vibration.
Power Requirement
1. Input voltage level: 220-240V 50Hz
Minimum Space Requirement
To avoid malfunction of the equipment through inadequate ventilation, allow sufficientair space around each machine.
t FRONT
This information is based on our present state of knowledge and is intended todescribe our products from the point of view of the safety requirements. It shouldnot therefore be construed as guaranteeing specific properties.
Issue Date: December 1993 Issue No: 2
Coinmercial Product Name:Safety Data SheetINFOTEC MASTERUNIT FOR
3660/3661/3665/366SG4FACSIMILES
Ref No: EI06
CHEMICAL FORMULA
IngredientsStilbene Derivative
PolycarbonateInorganic PigmentPigmentNt Subtrate1. Physical Data1.1 Melting/SofteningPointN ot Applicable1.2 BoilingPoint Not Applicable1.3 SpecificGravity Not Applicable1.4 pH,. Not Applicable1.5 Solubilityin water
Cas No.Not known25768-59-013463-87-7Notknown7440-02-0
% Contents1-5%1- 5%<2%<1%90%
DCDC°C
(at gIl water)soluble(gIl) miscible
20°C 0 01.6 Appearance & Odour Cartridge containing OPC Belt no Odour
insoluble.1.7 Physical form ( 200C) solid paste. o liquid
ogaseous
o1.8 Vapour pressure
1.9 Density Not Applicable g/ml
2. Storage stability and handling
2.1 Special precautions for transport Not subject to any transport or storage regulationsand storage
2.2 Incompatible substances None
2.3 Hazardous decomposition products Carbon monixide and other decomposition productsin the case of incomplete combustion
2.4 Hazardous reactions None
2.4.1 Preventative measures Not required under normal conditions of use
2.5 Protective measuresNot required under normal conditions of use
o respiratorso gloveso goggles
2.6 Technical protective measuresNot required under normal conditions of use
2.7 Measures after spillageNot Applicable
2.8 DisposalCan be deposited with household rubbish, local authorityregulations must be observed
~,?anka UK PLC':stirlingWayBorehamwoodHerts. WD6 2AETel: 01812ffl2700Fax: 0181 9535403
"( 1~
LWESTOR IN PEOPLE Certifk:ate No. FS :!0895
~ Office: Wharf House. The Wharf. Newbury, Berbhiro KGI4 SAP. Rtgistend ill EagIaod No. 2199112
- - --- -
Commercial Product Name INFOTEC MASTER UNIT FOR3660136611366S/366SG4FACSIMILES
3. Fire and explosion hazard
3.1. Flash point Not Apllicable o°C, method of determination:
3.2 Ignition temp. Not Applicable o°C, method of determination:
3.3. Extinguishing media . water mist. foam
,.
3.4.3.5
Special fire precautionsSpecial fire and explosion hazard
NoneNone
4. Information on toxicity
Ames Test Negative
5. Emergency and first.aid procedures
Not Applicable
6. Information on ecology
7. Special information
. C02
. dry powder
This information is based on our present state of knowledge and is intended to describe our productsfrom the point of view of the safety requirements. It should not therefore be construed as guarantee-ing specificproperties. . --..
Issue Date: December 1993
- --- - ---
Issue No: 2\.:}
top related