battaglia mario faccio pedro salazar andres 2015 sae aero design east competition faculty advisor:...

BATTAGLIA MARIO FACCIO PEDRO

SALAZAR ANDRES

2015 SAE Aero Design East Competition

Faculty Advisor: Dr. Dulikravich

Problem Statement

Design and build a remote control airplane that can lift as much payload as possible while meeting the restrictions given by the organizers of the event.

Represent Florida International University in the SAE Aero Design Series competition.

Design Objectives

Implement numerical analysis and knowledge acquired in the design process to solve a real-life challenge.

Research in several aerodynamic designs by performing wind tunnel testing

Analyze design alternatives based on cost and manufacturing possibilities

Optimized aircraft to obtain higher efficiency

Regular Class Requirements

Maximum combined length, width, and height of 175 inches.

Aircraft may not weight more than fifty-five pounds with payload.

The use if Fiber-Reinforced Plastic (FRP) is prohibited.

Single electrical motor configuration.

Design Evaluation

Phase 1 - Technical ReportPhase 2 - Technical Presentation and

InspectionPayload Loading DemonstrationPayload Unloading DemonstrationOral Presentation

Phase 3 - Flight Competition

Project Calendar

2015 SAE Aero Design East Competition Timeline

September October November December January March

10 15 25 5 10 15 20 25 5 10 15 20 25 5 10 15 20 25 5 10 15 20 25 13-15

Resarch

Design

Manufacture Fusilage/Wing/Tail

Assemble of Aircraft

Fly/Test

SAE Report Submision

SAE Presentation

SAE Competition

Responsibilities Of each member

Conceptual Design

• High Wing

• Conventional Tail

• Rectangular Wings

Wing Structure

8 ft wingspan.

1 inch aluminum tube

Eppler 423 Airfoil.

Tail Structure

Small tail due to competition parameters.

Balsa ribs and sheeting.

Fuselage Structure

Balsa and Light Ply.Nose compartment (motor and battery).Body compartment (competition weight).

Environmental & Economic Aspects

Materials used are recyclable.

No environmental impact.

Materials are relatively inexpensive

Manufacturing is relatively straightforward

Global Learning

Weight carried can represent a high definition camera, a first aid kit, food, or any small package that needs to be delivered.

The airplane model can be expanded to mapping or delivery planes, and our design can be presented to manufacturers in other countries.

Translation of instructions, used materials, parts, manufacturing process and units so that our design can be employed in different areas of the world.

Standards

System-Level Standards:

Design is complaint to SAE Aero Design East 2015 rules and regulations.

Component-Level Standards:

Guidance provided by the SAE on component usage is followed.