dpg digital pressure gauge instructions - winters...

DPG Digital Pressure Gauge Instructions

Tel: 1-800-WINTERS / www.winters.com WINTERS INSTRUMENTS

Menu Button• Press -Changespressureunits (psi,mH2O,mmHg,mbar,kParanges≤100psi, psi,bar,kg/cm2,MPa,atmranges≥160psi)

Hold for 4 - 5 Seconds and Release• - Resettozero (Thisprocesswilltakeafewseconds)

Power Button• Press -TurnsgaugeONforabout1minuteanddisplays batteryreading.Backlight*willstayONfor10sec -TurnsgaugeOFF(holdfor2sec)

• Press While ON -Turnsbacklight*backONfor10sec

*backlightautomaticallycomesONwhenpressure changes±10%ofscale(whengaugeisON)

LCD Display

Battery Reading

Pressure Reading

Pressure Scale (units)

1. 2.

3. 4.

5.

To Change Batteries

1. Remove Rubber Boot

2. Remove Top Phillips Screw to Open Cover

3. Exchange Batteries (Two AAA Batteries)

4. Close Cover and Re-install Screw

5. Re-install Rubber Boot

DPGDigital Pressure Gauge Instructions

WINTERS INSTRUMENTS Tel: 1-800-WINTERS / www.winters.comMKT5164

12/14

Setup Options

HoldMenu Buttonforabout6seconds

A) Displaywillshow“tP-nP”

B) PressMenu Buttonanddisplaywillshow“Pot=X”.Thisselectsthenumberofdigitsafterthedecimalpoint.Press Power Buttontoselect“2or3”(forranges≤100psi)or“3or4”(forranges≥160psi).

≤100psi

Pot=2: -Nodigitsafterdecimalpoint(mmHg,mbar) -Onedigitafterdecimalpoint(kPa) -Twodigitsafterdecimalpoint(psi,mH2O)

Pot=3: -Onedigitafterdecimalpoint(mmHg,mbar) -Twodigitsafterdecimalpoint(kPa) -Threedigitsafterdecimalpoint(psi,mH2O)

≥160psi

Pot=3: -Nodigitsafterdecimalpoint(psi) -Onedigitafterdecimalpoint(bar,kg/cm2,atm) -Twodigitsafterdecimalpoint(MPa)

Pot=4: -Onedigitafterdecimalpoint(psi) -Twodigitsafterdecimalpoint(bar,kg/cm2,atm) -Threedigitsafterdecimalpoint(MPa)

C) PressMenu ButtonandDisplaywillshow“OFF=0”.ThisselectstheAutoorManualShutOffmodes.PressPower Buttontoselect“0”or“1”. OFF=0:AutoShutOffmode;DisplayautomaticallyshutsOFFafterabout1minute OFF=1:ManualShutOffmode;DisplaywillremainconstantlyONuntilShutOffmanually(thelifeofthebatteriesisabout 15days).

D) PressMenu ButtonandDisplaywillshow“HL=0”.ThisselectstheDisplaymode.PressPower Buttontoselect“0”or“1”.

HL=0: Displayshowsactualandcontinuousprocesspressure HL=1: Displayshowsonlypeakprocesspressure*

E) PressMenuButtontoreturntoprocesspressuredisplay

*GaugeneedstobecycledON/OFFtobereset