for the ibanez rg20 terry mullett - engl-123 user manual assignment 1 maintaining your guitar lead...
Post on 27-Dec-2015
217 Views
Preview:
TRANSCRIPT
FOR THE IBANEZ RG20
Terry Mullett - Engl-123 User Manual Assignment
1
Maintaining Your Guitar
Lead GuitarWorks321 South Main Street, Kansas City, MO 64123
Keeping Your Guitar in Top Shape
Terry Mullett - Engl-123 User Manual Assignment
2
There are a few simple tasks that can keep your instrument playable.
Fresh StringsTuningString ActionIntonationNeck Adjustment
Fresh Strings
Terry Mullett - Engl-123 User Manual Assignment
3
Guitar strings wear out with time and use.
You can tell it’s time to change strings when
The strings are discolored
The sound becomes dull or fuzzy
The guitar is harder to keep in tune
Keep these things in mind about replacing strings:
You typically want to use the same string gauge (thickness) that is already on your guitar.
Cheap strings wear out faster.
Keep an extra set of strings handy in case a string breaks.
Fresh Strings: CAUTIONS
Terry Mullett - Engl-123 User Manual Assignment
4
Taking Care of Your Guitar Remove and replace strings ONE AT A TIME.
Removing all of the strings at once will cause a drastic change in neck tension. The neck may warp or crack during this procedure if you try to remove and replace the strings all at once.
Taking Care of Yourself String ends are SHARP.
The ends of guitar strings are like needles. Handle them with care and dispose of them properly.
1. Unwind the string with the tuning machine knob.1. Unwind the string with the tuning machine knob.
2. Push the loose string out through the tremolo.2. Push the loose string out through the tremolo.
Terry Mullett - Engl-123 User Manual Assignment
5
Fresh Strings: Removing Old Strings
Tuningmachines
Back ofTremolo
Strings exit through the holes
Fresh Strings: Replacing Strings
Terry Mullett - Engl-123 User Manual Assignment
61. Thread each new string in through the
tremolo and toward the headstock.
2. Be careful not to bend the string while pulling up through the tremolo.
3. About one inch past the tuning machine post, bend the string at a right angle.
4. Thread the string through the post up to the bend.
5. Turn the knob on the tuning machine to tighten the string.
6. Tighten to about one full tone beyond the normal tuning of the string.
For instance, tighten your new E string so that it sounds close to F#.
7. Stretch the new string by pulling firmly at a point near the middle of the string.
8. Repeat steps 6 and 7 until stretching the string does not change it’s pitch.
9. Tune the string to its normal pitch.
1” past the post, bend 90˚
Tuning
Terry Mullett - Engl-123 User Manual Assignment
7
A typical electronic tuner
There are several good ways to tune a guitar string.
Match the sound of another instrument, such as a piano.
Use an electronic tuner.Use a tuning fork.
We recommend an electronic tuner for convenience and accuracy.
String Action
Terry Mullett - Engl-123 User Manual Assignment
8String Action is the height of the
strings above the fretboard. If action is too high, the guitar
will be difficult to play. If action is too low, the strings
will buzz against the frets.
1. String action is adjusted at the bridge. It is measured at the 14th fret.
2. On the bass side, the distance should be 1.5 mm.
3. On the treble side, the distance should be 2 mm.
4. The distances for the strings in between should gradually go from 1.5 mm to 2 mm.
Adjust here
Measure here
Intonation
Terry Mullett - Engl-123 User Manual Assignment
9Intonation adjusts the overall
tuning of a string. A string can be tuned for the correct pitch at the open position, but still be out of tune when played at a fret.
To adjust intonation:1. Tune the string to the proper
pitch when played open. 2. Adjust the intonation screw
(on the tail of the bridge) so that the pitch is exactly an octave higher when the string is played at the 12th fret.
3. Repeat until no further adjustment is necessary.
1 octave apart
Adjust here
Neck Adjustment
Terry Mullett - Engl-123 User Manual Assignment
10 CAUTION!
It is very easy to damage a guitar by adjusting the neck improperly. We recommend that you leave this to an experienced professional.
The neck adjustment nut is used when the string action or intonation cannot be properly adjusted.
Neck adjustment problems can be caused by moisture, temperature, or a change in string gauge.
Tightening the adjustment nut bends the neck forward. Loosening it causes the neck to bend farther back.
Neck adjustment nut
Recessed in the headstock
Resources
Terry Mullett - Engl-123 User Manual Assignment
11
You can learn more about the Ibanez RG20 athttp://www.ibanez.com
See especially:http://www.ibanez.com/support/manuals/guitars_basses.pdf
To learn more about maximizing the performance and playability of your instrument, visit the experts at Lead GuitarWorks.http://www.leadguitarworks.com
top related