knuckle inventor.pdf

AUTODESK INVENTOR FILE CO12106

FORK END

Draw the sketch with given dimension and constraints.

Extrude it for 120 mm.

Select the top surface and draw the sketch

Use extrude and cut the inner piece.

AUTODESK INVENTOR FILE CO12106

Draw the sketch using two circle and constraining them as tangent

Cut the above portions.

Select the given surface, draw the circle and extrude it for 25mm.

AUTODESK INVENTOR FILE CO12106

Use fillet tool and round it for 2 mm.

Draw the given sketch on the side view.

Use the revolve command

Revolve for 360 degree and revolve around edge.

Use mirror feature select the feature and corresponding tool

Repeat it twice till the desired product is obtained.

AUTODESK INVENTOR FILE CO12106

AUTODESK INVENTOR FILE CO12106

EYE END

Draw the above given sketch with following dimensions.

Select extrude ,and extrude it to 60 mm.

AUTODESK INVENTOR FILE CO12106

Again draw the given sketch using suitable constraints ,lines and

circles.

Select revolve and revolve around the corresponding edge.

Use mirror feature .

Select the given feature and mirror it around the given axis.

Select the given feature and mirror it around the given plane.

AUTODESK INVENTOR FILE CO12106

Draw the given sketch on the corresponding surface.

Extrude it for 20mm.

Use fillet feature command ,use it for 2 mm

AUTODESK INVENTOR FILE CO12106

AUTODESK INVENTOR FILE CO12106

KNUCKLE PIN

Draw the above sketch, ectrude it for 10mm.

After extrusion again draw the sketch and extrude it for 150 mm.

The extrusion will look like this.

AUTODESK INVENTOR FILE CO12106

Select the above plane and draw the circle on it.

Select extrusion on it and remove material from it thus creating a

hole in it.

AUTODESK INVENTOR FILE CO12106

COLLOR

Draw two concentric circles of diameter of 50mm and .

Select extrude and extrude it for 25 mm.

Select plane perpendicular to surface

Draw a circle of dia 3mm.

Select extrude use cut both ways and remove material.

AUTODESK INVENTOR FILE CO12106

The collor will look like this.

AUTODESK INVENTOR FILE CO12106

PIN

Draw a circle of diameter 6 mm .

Extrude it for 70 mm.

AUTODESK INVENTOR FILE CO12106

ASSEMBLY OF KNUCKLE JOINT

Place the fork end using insert component.

AUTODESK INVENTOR FILE CO12106

Insert the eye end and mate the circular sufaces.

Again mate the axis of both the circular ends.

Then use the angle constraint

Align the axis perpendicular to each other.

.

Insert a new component knuckle pin.

Mate the inner and outer cylindrical surfaces as shown

Then mate the top end of the pin with the protruding end.

AUTODESK INVENTOR FILE CO12106

AUTODESK INVENTOR FILE CO12106

Insert the collor using place component.

Mate the axis of hole to the axis of the knuckle pin.

Lastly insert the pin using the axis of collor and knuckle pin.

AUTODESK INVENTOR FILE CO12106

KNUCKLE JOINT

AUTODESK INVENTOR FILE CO12106

SUBMITTED TO:

MR. NIPUN SHARMA

AUTODESK INVENTOR FILE CO12106

AUTODESK INVENTOR FILE CO12106

AUTODESK INVENTOR FILE CO12106

AUTODESK INVENTOR FILE CO12106

AUTODESK INVENTOR FILE CO12106