7/30/2019 Case Study for Tividale Hall Primary School.pdf

1/2

Sandwell MBC

Sandwell Homes

Education

CanVent System

Cooking Equipment

Input & Extract System

Front Entrance

CanVent Wall Mounted Kitchen Canopy

Working closely with Sandwell MBC, Airtherm Engineering have recently

completed the new installation of a kitchen ventilation system, including a

complete control solution that features a thyristor, speed regulators and gas

interlock.

The existing canopy was made of a metal and glass construction which we

removed from site, and a stainless steel wall mounted extraction canopy was

designed and installed in it's place, complete with a provision for tempered

make-up air.

The project had a very tight schedule, however, our expert installation team

ensured the system was fully operational prior to the School kitchen re-

opening on Friday 31st August 2012.Control Solution

7/30/2019 Case Study for Tividale Hall Primary School.pdf

2/2

Product Range

Our product range extends from simple condense canopies, extract only, island or wallmounted canopies, through to our air injection island systems allowing both input and

extract. If required, the input air can be pre-heated for additional internal staff

comfort during the cold winter months. All products can be configured to suit each

individual application.

Manufacture

All canopies are manufactured from 304 (En 1.4301) or 316 (En 1.4401) stainless steel

where specified and are suitably braced to prevent product distortion. All joints are

welded and polished.

Our Canopies are cut, punched and folded into sub sections and factory assembled by

means of computer controlled seam welds, and non-visible mechanical fixings.

Systems are manufactured to the strict guidelines of DW/172, British Standards and

conform to HSE for commercial kitchen ventilation. Wall mounted or island canopies

can be manufactured to meet almost any dimension but typically 1000mm to 8000mm

long. The system ductwork is manufactured and installed to incorporate cleaning and

maintenance access doors to fully comply with DW/144 & TR/19 standards.

Allowances:

a) High efficiency stainless steel grease eliminator baffles cells.

b) Grease control system with removable drawers.

c) Factory fitted duct connection collars.

d) Twin fluorescent recessed luminaries manufactured to IP65, steam heat and grease-

proof to provide and average illumination level of 500 lux upon the working plane

below. All pre-wired to junction box situated using heat resistant flex cable.

e) Galvanised ductwork to DW 144 HVCA standards allowing for single wall 0.8mmthk.

f) 2No short cased Elta fans, single phase supply C/w ancillary components & speed

controllers.

g) 20kw heater battery & control system

h) 2No 150mm x 50mm x 2000mm high stainless steel support columns located either

end of unit.

i) 1No 3600mm long x 220mm wide stainless steel rear valance to enclose pipes /

services.

Airtherm Engineering Ltd

Ventilation House

Pedmore

Stoubridge

West Midlands

DY9 0DS

Tel: 0844 8092509

Fax: 01562 887312

xtract Canopy

Grease Filters

xternal Extract & Input Ductwork