chapter 5 the x-ray imaging system

15
CHAPTER 5 THE X-RAY IMAGING SYSTEM SPECIFIC OBJECTIVES NOTED IN THIS POWER POINT BEGIN ON PAGE 90-101.

Upload: benedict-davis

Post on 31-Dec-2015

102 views

Category:

Documents


12 download

DESCRIPTION

CHAPTER 5 THE X-RAY IMAGING SYSTEM SPECIFIC OBJECTIVES NOTED IN THIS POWER POINT BEGIN ON PAGE 90-101. Four timers. 1) Synchronous-min time is 1/60. Increase in equal multiples 2) Electronic-most accurate/controlled by microprocessor Where are 1 and 2 located in the circuit? - PowerPoint PPT Presentation

TRANSCRIPT

Page 1: CHAPTER 5  THE X-RAY IMAGING SYSTEM

CHAPTER 5 THE X-RAY IMAGING SYSTEMSPECIFIC OBJECTIVES NOTED IN THIS

POWER POINT BEGIN ON PAGE 90-101.

Page 2: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• 1) Synchronous-min time is 1/60. Increase in equal multiples

• 2) Electronic-most accurate/controlled by microprocessor

• Where are 1 and 2 located in the circuit?• mAs time and falling load generator-let’s

discuss this! (Page 90)

Four timers

Page 3: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• WHAT IS THE PURPOSE OF AN AEC?

• HOW DO YOU USE THEM WHEN POSITIONING?

• CHAMBERS VS. PHOTOMULTIPLIERS

• Can they produce the same density of radiograph for any size patient?

AEC pg 92 Bushong, Chapter 8, Fauber

Page 4: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• Waits for a charge• Sequence

– X-ray– Patient– Ion chamber– IR

• Collects a charge via light

• Sequence– X-ray – Patient– Special cassette– photodiode

Ion chamber vs photomultiplier or photodiode

Page 5: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• APR• Page 211 Fauber

Anatomically Programmed Radiography

Page 6: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• What do you remember?

High Voltage Transformer

Page 7: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• Unrectified

• Half wave rectified

• Fully rectified

RECTIFICATION, Bushong 93

Page 8: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• Single

• Three phase

• Three phase/6 pulse

• Three phase/12 pulse

• High Frequency• How do these phases

impact technique??

• 100%

• 13 or 14%

• 3 or 4%

• Less than 1%

Phases Voltage Ripplepage 26 Fauber figure 2-13, Bushong, pg 97,99

Page 9: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• UNIT OF MEASUREMENT OF POWER IS WATTS• AMPS MEASURES THE QUANTITY OR QUALITY?• Volts measures the ________________________ • Amps=current• Volts = potential

• Try this problem: If your kitchen is on a 25 amp circuit breaker and 110 volts is the available voltage what is the maximum watts this circuit can handle?

• ON TO CHAPTER SIX!!

POWER RATING

Page 10: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• REVIEW THE PROTECTIVE HOUSING• Let’s dissect the cathode• What happens at the cathode?• Focusing cup

– Imbedded in cathode– Two (page 13 in fauber, figure 2-1)– Confines the electron beam

• Grid controlled tubes• Allows for tube to be turned off and on

quickly• Space charge and space charge effect

– High mAs and low kVp can be space charge limited..why?

CHAPTER SIX, Bushong

Page 11: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• Three functions of the anode -What do you know already about the anode

• The target

• What does the rotor do?

• Note: please skip induction motors at this time

The Anode

Page 12: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• Focal spot and target angle (Fauber pg 31 figure 2-2)

• The smaller focal spot– More concentration of heat– Better detail– Usually located in the smaller angle

• Large focal spot– Less concentration of heat– Less detail– Larger angle– Page 32 Fauber, figure 2-18

Focal spot, line focus principle and anode heel effect, Bushong, 107-115,Fauber 23-32

Page 13: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• Effective focal spot size is always smaller than the actual focal spot size

• Fauber-pg 31 figure 2-16, figure 2-17

Line Focus Principle

Page 14: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• Bushong pg 130, pg 7-20• The heel effect is more or less with a

greater angle?• Which side has greatest intensity?• Off Focus radiation

Anode Heel effect

Page 15: CHAPTER 5  THE X-RAY IMAGING SYSTEM

• Tube rating charts• Heat units• Anode cooling charts

How is heat dissipated in the tube?