complete the following drawing measurements on the next two slides
TRANSCRIPT
Complete the following drawing
Measurements on the next two slides
5-7
5-8
Email your finished work to Mr. Scott by eplotting the file titled 5-7 & 8 your name on subject line.
Your name Period Date
Result of DWF6eplot
Set to DWF 6eplot
Try this one when you are finished
Orthographic 5-7
Orthographic 5-8
Orthographic 5-9
SEND DRAWING TO [email protected]
SUBMISSION OF SOLIDS, BE SURE TO LABEL
October 7th
• We are going to begin using a Journal to save our work. All our drawings to date, with name, date, project name, and evaluation will go into the journal. They will be stored on the shelf in the back of the room by period.
• The goal is to collect all your work in one place.• To see growth and refinement of your skills with
CAD and understanding of drafting fundamentals.
Next drawing in the series, 5-10
5-10New drawingCreate layersBegin the drawing at 4, 4
Create the Orthographic drawing for this model, this time, you will only need the Front and Right side of the drawing.Linetype (load the Center and Hidden Lines)DDIM ( SET THE DIMENSIONS and Dimension your project.)Save-as 5-12 TSCOTT ORTHO.dwgUse your name
FINAL DOCUMENT: SUBMIT AS DWG TO PDF, ATTACH TO MESSAGE AND SEND TO MR. SCOTT. SAVE AS YOUR NAME, FILE NUMBER CLASS. TSCOTT 5-10 1ST
5-11New drawingCreate layersBegin the drawing at 4,2
Create the Orthographic drawing for this model, this time, you will only need the Front and Right side of the drawing.Linetype (load the Center and Hidden Lines)DDIM ( SET THE DIMENSIONS and Dimension your project.)Save-as 5-11 TSCOTT ORTHO.dwg(use your name)
5-11New drawingCreate layersBegin the drawing at 4,2
Create the Orthographic drawing for this model, this time, you will only need the Front and Right side of the drawing.Linetype (load the Center and Hidden Lines)DDIM ( SET THE DIMENSIONS and Dimension your project.)Save-as 5-11 TSCOTT ORTHO.dwg (use your name)
FINAL DOCUMENT: SUBMIT AS DWG TO PDF, ATTACH TO MESSAGE AND SEND TO MR. SCOTT. SAVE AS YOUR NAME, FILE NUMBER CLASS. TSCOTT 5-11 1ST
5-12New drawingCreate layersBegin the drawing at 2,2
Create the Orthographic drawing for this model, this time, you will only need the Front and Right side of the drawing.Linetype (load the Center and Hidden Lines)DDIM ( SET THE DIMENSIONS and Dimension your project.)Save-as 5-12 TSCOTT ORTHO.dwg
5-13 Metric• New drawing• Units (mm) must change to mm.• Create layers• Begin the drawing at 2,2
• Create the Orthographic drawing for this model, this time, you will only need the Front and Right side of the drawing.
• Linetype (load the Center and Hidden Lines)
• DDIM ( SET THE DIMENSIONS and Dimension your project.) set the measurement scale to 25.4 (1 inch equals 25.4 mm)
• Save-as 5-13 TSCOTT ORTHO.dwg
5-13 Metric
T SCOTT10-13-2014ENGINEERING DESIGN 5-14 ORTHOGRAPHIC
T SCOTT10-13-2014ENGINEERING DESIGN 5-15 ORTHOGRAPHIC