corning cabelcon 1. 2 to begin with – we need some tools… cable cutter cabelcon rg11 rotary...
TRANSCRIPT
CorningCabelcon
1
CorningCabelcon
2
To begin with – we need some tools…
Cablecutter
Cabelcon RG11 Rotary Stripper
Mounting tools
Compression tool
Please read the instructions
before using the tools!
CorningCabelcon
3
Let’s start to work…
First step is to cut your cable using a
proper cable cutter.
CorningCabelcon
4
Strip your cable…
Insert the cable into the cable stripper as
shown…
Attention: Please make sure to adjust the tool blades for your cable dimensions before using it for the first time! Please read instructions supplied with the tool.
Screws for adjustment of blades
Hex tool for adjustment
CorningCabelcon
5
Strip your cable…
Turn the stripper clockwise 4-5 times…
CorningCabelcon
6
Strip your cable…
- Press the tool jaws together around the
cable and pull to remove the scraps…
CorningCabelcon
7
Strip your cable…
Optional:
You can check the stripping dimensions against the guide printed on the connectors
6,5 + 6,5 mm (¼” + ¼”)
CorningCabelcon
8
Prepare your cable…
Fold exposed braid over the jacket.
Leave the inner foil attached to the dielectric
and make sure that the foil is undamaged and smooth.
For ”Quad shield”, ”Tri shield”
and ”Super shield” cables: Remove the outer braid and foil only. Fold back the inner
braid.
CorningCabelcon
9
Push the connector over the foil and allow the support mandrel to slide between the foil and braid…
Mount the connector…
CorningCabelcon
10
Press and turn until the pin is pushed forward and visible as shown.
Mount the connector…
Mounting tools can be used to ensure a better grip on both connector and the cable…
CorningCabelcon
11
Compress the connector…1) Insert your connector/cable into the tool with the tool handle in open position…
2) Apply a downward pressure on the cable to allow the split jaws to secure the cable…
Click!
CorningCabelcon
12
Compress the connector…
- and close the tool handle completely insuring the connector sleeve is fully compressed.
CorningCabelcon
13
Open the tool - press the outside split-jaw tabs and pull out the connector assembly…
Take out the connector…
CX3 RG7/11 Compression completed!
CorningCabelcon
14
The inner conductor grip is very precise due to the movable pin system.You cannot miss it.
Use your scroll mouse or the arrow keys to go forward and back…
Insert cable
This how the movable pin technology works…
CorningCabelcon
15
Insert cable
Use your scroll mouse or the arrow keys to go forward and back…
This how the movable pin technology works…
The inner conductor moves forward to indicate proper installation when the cable is pushed forward in place.
CorningCabelcon
16
Use your scroll mouse or the arrow keys to go forward and back…
Compression locks the cable and terminates the installation.
This how the movable pin technology works…
CorningCabelcon
17CorningCabelcon
17
Thank you for watching this instruction
January 2008