cr102 se rie s cable redu ction box · 2020. 6. 1. · w rng insrcns cr102 se rie s cable redu...
TRANSCRIPT
-
Wiring instructionsCR102 SeRieS Cable ReduCtion boxCR102 SeRieS Cable ReduCtion box
1. Strip outer jacket of cable back 1¼ in. and remove all of the shielding.
2. Separate the internal wires from the shield and twist the shield.
3. Strip red and black insulation back ¼ in.
4. Locate the appropriate plug, identified by channel number, remove the plug and install the wires using a small flathead screwdriver. Push plug back into location.
Orientation is as follows: a. Red insulated conductor wire is connected to (+). b. Black insulated conductor wire is connected to (-). c. Shield drain wire is connected to ground (GND). d. Depress selected position button on input terminal block to open terminal for respective wire. (May need mini flat head screwdriver).
(-) Common
Shield / Drain wire
(+) Signal / Power1¼”
¼”
Visit our website to download the full manual for CR102 enclosures.
https://www.ctconline.com/epicor/MM-CR102-12_Rev_A.pdf
-
Wiring instructionsCR102 SeRieS Cable ReduCtion boxCR102 SeRieS Cable ReduCtion box
ENSIONS E SHEET
INPUTS OUTPUTS
SENSOR INPUTS Red/White = Positive Black = Common Grey = Shield/Ground
ENSIONS E SHEET
INPUTS OUTPUTS
SENSOR INPUTS Red/White = Positive Black = Common Grey = Shield/Ground
Inputs Outputs
Mw-Cr102-12/Rev A