cricket poster holder mounting instructions · cricket poster holder ... drill a 3/16" hole in...
TRANSCRIPT
Cricket Poster Holder Mounting Instructions
1. Mark the overall height 91"h and center point of the middle poster of the three poster grouping. The center point should be the center of the Device Fixture. Place one of the grey brackets on the wall in the orientation shown in Fig 1. The very top of the bracket should be at the same height as the predetermined overall height and centered on the center point. Mark the pre drilled holes on the bracket onto the wall.
2. Drill a 3/16" hole in each marked location and tap in a wall molly. Mount a grey bracket to the wall using supplied 1 1/4" screws in the orientation shown in Fig 1.
© Palmer Promotional Products 2008 3/25/2010
23001 W. Industrial Dr. • St. Clair Shores, MI 48080 USA www.palmerpromos.comPhone: 586.772.4225 • Fax: 586.772.4627
3. Measure from the bottom of this bracket down 23.375". Place the second bracket on the wall at this height directly below the other bracket. The orientation of the bottom bracket will be opposite that of the upper bracket, see Fig 2.
4. Mount the bottom bracket in the exact same manner as the upper bracket was mounted. See step 2.
Overall height
Overall center of postergrouping
Fig 1
Hole for mounting bracket Hole for mounting
bracket
23.375"
Bottom bracket mountedin opposite orientation.
Fig 2
Cricket Poster Holder Mounting Instructions
© Palmer Promotional Products 2008 3/25/2010
23001 W. Industrial Dr. • St. Clair Shores, MI 48080 USA www.palmerpromos.comPhone: 586.772.4225 • Fax: 586.772.4627
5. Measure 5/8" from the left and right edge of each bracket and 3" down from the overall height line. These will deter-mine the inside and top edge of the side posters. Place one of the side poster holders up on the wall lining the inside and top measurements up and leveling the poster holder. Open the hinged frame of the poster holder and mark the holes on the wall that are inside the top and bottom frame.
6. Drill a 3/16” hole in each marked location and tap in a wall molly. Mount poster holder the wall using supplied 1 1/4” screws in the orientation shown in Fig 3.
3"down from overall height3"down from overall height
Fig 3
5/8"
Open hinged frame.Mounting holes are
inside top and bottom frame.
Open hinged frame.Mounting holes are
inside top and bottom frame.
7.5"
7.5" 7.5"
1.75"
1.75"
7. Place the middle poster holder up against the brackets, centered, so the top of the poster holder is even with the top of the upper bracket. Measure 7.5" in from the left and the right edge, and 1.75" up from the bottom edge and down from the top edge. Mark where these four points meet. See Fig 4.
8. Usingthesuppliedshortflatheadscrews,drivethescrewsdirectlythroughthewhitehardboardatthemarkedloca-tions into the brackets behind.
7.5"
Fig 4
5/8" 5/8"
5/8"
Hole for mounting center poster holder