WELD FIXTURES THAT WORK
Fine-tune the location of Sub Assemblies
Using..
RB19
RB11
Using..
RB19
RB12
OR Using..
RB19
And ...
RB16
Locating pins are often used in weld fixtures.
This pin is inserted into the product part to be welded…
This pin is inserted into a critical-dimensioned hole
in the product part to be welded…
The clamp moves the pin forward and back…
…and moves the pin so the welded product can be removed from the fixture.
… During the first test run of the fixture, the product parts are welded…
… and measured …
If the product is out of tolerance range, the fixture is adjusted.
RAPid Block™RB19
How it works...
RAPid Block™RB19 is designed to mount to a base plate and not move.
How it works...
RAPid Block™RB19 has three C’bored holes for Socket Head Cap Screws.
How it works...
And thru holes for press fit dowels.
Rentapen’s RB19 ...
.
The dowelsdo not go through, but penetrate from the bottom a small amount.
How it works...
The plate the clamp is mounted to...
How it works...
…is fastened to RB19…
How it works...
…through steel shims…
How it works...
…RB16 hasOne dowel hole
One Slot
and two C’bored holes.
Rentapen’s RB19 & RB16 ...Slots allow the fasteners room to move sideways
In this case shims are not needed between RB16 and the plate the clamp is mounted to.
In this case shims are between the RAPid Block™ and the sub-assy.
To adjust the whole sub assembly in relation to the other sub assemblies in this fixture.
The clamp plate is fastened to the RB16.
If the product is out of tolerance range, the fixture is adjusted.
Pack of thin, steel shims
RAPid Block™RB19
If the product is out of tolerance range, the fixture is adjusted.
Pack of thin, steel shims
Get your adjustment Shims from Rentapen.
RAPid Shims™ from RENTAPEN
To move the locating pin right, .01” add a .01” thick shim.
Add a shim here…
RAPid Block™RB19
To move the locating pin left .03” remove .03” of shims.
Remove a shim here…
Clamp plate is tightened down to base plate.
Remove a shim here…
Over-sized drilled hole or slot allows for adjustment.
Remove a shim here…
Washer.
Remove a shim here…
Washers or plates over slots or over sized holes…
Adjusting in verticle direction…
Adjusting in vertical direction…
With RB16 and RB19 slots only allow for side to side adjustment…
Can use up to ¼” shim packs for larger adjustments …
…for adjustment in the 3rd direction…
…Place shims under components.
RB11 & RB12 ...
RB19
RB11RB12
RB11 & RB12 ...
RB19
Allow 3-way adjustment
RB11 & RB12 ...
RB19
Allow 3-way adjustment
RB11 & RB12 ...
RB19
Oversized holes
RB11 & RB12 ...
RB19
Can use up to 1/8” shim pack
RB11 & RB12 ...
RB19
Shims can go under plate
RB11 & RB12 ...
RB19
Adjustable in 3 directions
Rentapen Inc.
Rentapen Inc.
Design
Rentapen Inc.
Build
Rentapen Inc.
RAPid Tooling Components ™
Rentapen Inc.
Precision Steel Shims
SAVE TIME…
www.rentapen.com
www.rentapen.com
262-542-8891