1 Pressure Vessel Engineering Ltd.2 Finite Element Analysis ASME Code Calculations3 Canadian Vessel Registration Vessel Modeling and Drafting

4 Page 1 of 1

5 Cone Inputs:6 Sample Cone Description7 24.008 12.009 5.00010 0.25011

12

13

14

15

16 Calculated Variables:17 ((LOD-2*t)-SOD)/2 ((24-2*0.25)-12)/2 = 5.75018 ATAN(Y/L) ATAN(5.75/5) = 0.85519 SQRT(Y^2+L^2) SQRT(5.75^2+5^2) = 7.62020 SQRT(BL^2+t^2) SQRT(7.62^2+0.25^2) = 7.62421 ATAN(t/DL) ATAN(0.25/7.624) = 0.03322 Degrees(G+B) DEGREES(0.033+0.855) = 50.923 (t*cos(Radians(GB)))/2 (0.25*COS(RADIANS(50.9)))/2 = 0.07924 (LOD-2*t)/2+Y2 (24-2*0.25)/2+0.079 = 11.82925 SOD/2-Y2 12/2-0.079 = 5.921

26 Layout Dimensions:27 DDI/(sin(Radians(GB))) 5.921/(SIN(RADIANS(50.9))) = 7.63328 DDO/(sin(Radians(GB))) 11.829/(SIN(RADIANS(50.9))) = 15.24929 (DDI/Ri)*360 (5.921/7.633)*360 = 279.254

30 Comments:31 - This program calculates thickness corrected cones where

32 the inside of the large end of the cone touches the inside

33 of the large pipe and where the outside of the small end of the

34 cone touches the outside of the small pipe.

35 - Ri, Ro and all lines share the same origin.

36 - The prebend tabs shown here are used for some pyramid

37 rollers if required.

38 - If a brake press is used to bend the cone, then all bend lines

39 should pass through the origin.

40 - This program assumes that the large pipe has the same thickness as the cone. The thickness of the small pipe is ignored.

41 - Adjust the length of the cone if required to get the desired cone angle GB.

42 - This program is intended for educational use only. Pressure Vessel Engineering Ltd. Is not responsible for its use.

43 Pressure Vessel Engineering Ltd.44 120 Randall Drive, Suite B45 Waterloo, Ontario, Canada, N2V 1C646

Cone Layout Tool ver E4.02

LOD [in] - OD of the large pipe SOD [in] - OD of the small pipe L [in] - cone length t [in] - cone and large pipe thickness

Y [in] =B [rad] =BL [in] =DL [in] =G [rad] =

GB [deg] =Y2 [in] =

DDO [in] =DDI [in] =

Ri [in] =Ro [in] =

Theta [deg] =

www.pveng.com (519) 880-9808

L

SOD

LOD

tGB

Theta

Ro

Ri

BendLines

OriginPre-bend