01/2017
Tensioner
Available from leading Builders Supply Merchantsthroughout New Zealand
MULTI-BRACEUSE STAINLESS STEEL OPTION IN EXTERIOR
SITUATIONS
Commercial and Industrial Roof/Wall BracingEconomically comparable to Steel Rod or Timber Bracing systemsQuick and easy to apply
Loadings
Tensioner Use tensioner to ensure Multi-Brace is taut prior to roof fixing. Note: Not available in Stainless Steel so tension must be provided during installation phase.
Availability Multi-Brace is available in 10m, 15m and 30m coil lengths which may be ordered through your local LUMBERLOK merchant.
3 nails top edge, 8 nails vertical face (not in same line)
35mm Optimum
TENSIONER ASSEMBLEDON TO MULTI-BRACE
To adjust Multi-Brace tensiontighten nuts to draw crossbarsup ramp.
BREAKDOWN OFTENSIONER COMPONENTS
Note: Creased side to face ramp
Crossbar
Ramp
AdjustingBolts
Fix Multi-Brace endfor loadings below.
35mm Optimum
TENSIONER ASSEMBLEDON TO MULTI-BRACE
To adjust Multi-Brace tensiontighten nuts to draw crossbarsup ramp.
BREAKDOWN OFTENSIONER COMPONENTS
Note: Creased side to face ramp
Crossbar
Ramp
AdjustingBolts
Fix Multi-Brace endfor loadings below.
0.91mm x 53mm G300 Z275 GALVANISED STEEL0.9mm x 53mm STAINLESS STEEL 304-2B
Tension Multi-Brace Only Multi-Brace With Tensioner
Characteristic Load 14.8kN 14.8kN
Elongation 0.2mm/m/kN including nail slip
End nail fixing - 11 x LUMBERLOK Product Nails 30mm x 3.15 dia. if Multi-Brace is folded over timber face. Otherwise use 15 Product Nails.
35mm Optimum
TENSIONER ASSEMBLEDON TO MULTI-BRACE
To adjust Multi-Brace tensiontighten nuts to draw crossbarsup ramp.
BREAKDOWN OFTENSIONER COMPONENTS
Note: Creased side to face ramp
Crossbar
Ramp
AdjustingBolts
Fix Multi-Brace endfor loadings below.
*