01/2017

Tensioner

Available from leading Builders Supply Merchantsthroughout New Zealand

MULTI-BRACEUSE STAINLESS STEEL OPTION IN EXTERIOR

SITUATIONS

Commercial and Industrial Roof/Wall BracingEconomically comparable to Steel Rod or Timber Bracing systemsQuick and easy to apply

Loadings

Tensioner Use tensioner to ensure Multi-Brace is taut prior to roof fixing. Note: Not available in Stainless Steel so tension must be provided during installation phase.

Availability Multi-Brace is available in 10m, 15m and 30m coil lengths which may be ordered through your local LUMBERLOK merchant.

3 nails top edge, 8 nails vertical face (not in same line)

35mm Optimum

TENSIONER ASSEMBLEDON TO MULTI-BRACE

To adjust Multi-Brace tensiontighten nuts to draw crossbarsup ramp.

BREAKDOWN OFTENSIONER COMPONENTS

Note: Creased side to face ramp

Crossbar

Ramp

AdjustingBolts

Fix Multi-Brace endfor loadings below.

35mm Optimum

TENSIONER ASSEMBLEDON TO MULTI-BRACE

To adjust Multi-Brace tensiontighten nuts to draw crossbarsup ramp.

BREAKDOWN OFTENSIONER COMPONENTS

Note: Creased side to face ramp

Crossbar

Ramp

AdjustingBolts

Fix Multi-Brace endfor loadings below.

0.91mm x 53mm G300 Z275 GALVANISED STEEL0.9mm x 53mm STAINLESS STEEL 304-2B

Tension Multi-Brace Only Multi-Brace With Tensioner

Characteristic Load 14.8kN 14.8kN

Elongation 0.2mm/m/kN including nail slip

End nail fixing - 11 x LUMBERLOK Product Nails 30mm x 3.15 dia. if Multi-Brace is folded over timber face. Otherwise use 15 Product Nails.

35mm Optimum

TENSIONER ASSEMBLEDON TO MULTI-BRACE

To adjust Multi-Brace tensiontighten nuts to draw crossbarsup ramp.

BREAKDOWN OFTENSIONER COMPONENTS

Note: Creased side to face ramp

Crossbar

Ramp

AdjustingBolts

Fix Multi-Brace endfor loadings below.

*