Download - Stove Does Not Respond
-
8/14/2019 Stove Does Not Respond
1/1
Stove Does Not RespondNormal Operation Sequence
10 - Plug the Stove In
H:\Tech Support\Training\SMTSG - Stove Does Not Respond.doc
11 LED's indicate P.O.S.T.12 Burn Drive cycles three (3) times13 Exhaust Fan Runs for 30 min then OFF
20 - Startup Mode
21 Push ON Button & set Heat Level22 #1 LED on23 Number of LED's show Set Heat Level24 Burn Drive cycles three (3) times25 Feed Wheel Begins Feeding Fuel26 After 1 minutes, Air pump comes ON27 After 15 seconds, the Igniters turn ON28 Within 5 minutes, Smoke and than Flame29 Igniters turn OFF after Flame is established30 After 15 seconds the Air Pump goes OFF31 Stove Ramps to Heat Level 432 After 20 minute Startup Period, stove ramps
up or down to User Set Heat Level
40 - Normal Run mode
41 Stove runs at User SET HEAT Level42 Ash Dump per Heat Level43 Stove ramps to Heat Level 4 during the Ash
Dump process44 Stove runs until User turns the Stove OFF
50 - Normal Shut Down Mode
51 Push the OFF Button52 Feeder Wheel Stops feeding Fuel53 1st 10 minutes Exhaust Fan Increases speed54 Next 20 minutes Exh. Fan runs at 50% speed55 After 30 min. total, Ash Dump, Stove is OFF
NOYES
YESNO
LED is NOT LIT on the Mother Board (RED / 115) (GREEN / UBB)
Check for Power at the ReceptacleContact Electrician
Run Stove
Check for 120v at Mother Board AcrossRED & WHITE wires - (J4 / 115) (J3 / UBB)
Unplug Stove
Push the ON Button20
40
Remove and Test F3
BAD
GOOD
Replace Fuse F3 with:125v 5amp or 6amp
Bussman GMA SeriesLittleFuse 217 / 218 SeriesShawmut GGM Series
10Plug Stove In
No Response
LED on Mother Board Lights
Check ALL Connections BetweenCord End - Repair or Replace as
Necessary
Replace Mother Boardas per Kit Instructions
Unplug Stove