8/14/2019 Stove Does Not Respond

1/1

Stove Does Not RespondNormal Operation Sequence

10 - Plug the Stove In

H:\Tech Support\Training\SMTSG - Stove Does Not Respond.doc

11 LED's indicate P.O.S.T.12 Burn Drive cycles three (3) times13 Exhaust Fan Runs for 30 min then OFF

20 - Startup Mode

21 Push ON Button & set Heat Level22 #1 LED on23 Number of LED's show Set Heat Level24 Burn Drive cycles three (3) times25 Feed Wheel Begins Feeding Fuel26 After 1 minutes, Air pump comes ON27 After 15 seconds, the Igniters turn ON28 Within 5 minutes, Smoke and than Flame29 Igniters turn OFF after Flame is established30 After 15 seconds the Air Pump goes OFF31 Stove Ramps to Heat Level 432 After 20 minute Startup Period, stove ramps

up or down to User Set Heat Level

40 - Normal Run mode

41 Stove runs at User SET HEAT Level42 Ash Dump per Heat Level43 Stove ramps to Heat Level 4 during the Ash

Dump process44 Stove runs until User turns the Stove OFF

50 - Normal Shut Down Mode

51 Push the OFF Button52 Feeder Wheel Stops feeding Fuel53 1st 10 minutes Exhaust Fan Increases speed54 Next 20 minutes Exh. Fan runs at 50% speed55 After 30 min. total, Ash Dump, Stove is OFF

NOYES

YESNO

LED is NOT LIT on the Mother Board (RED / 115) (GREEN / UBB)

Check for Power at the ReceptacleContact Electrician

Run Stove

Check for 120v at Mother Board AcrossRED & WHITE wires - (J4 / 115) (J3 / UBB)

Unplug Stove

Push the ON Button20

40

Remove and Test F3

BAD

GOOD

Replace Fuse F3 with:125v 5amp or 6amp

Bussman GMA SeriesLittleFuse 217 / 218 SeriesShawmut GGM Series

10Plug Stove In

No Response

LED on Mother Board Lights

Check ALL Connections BetweenCord End - Repair or Replace as

Necessary

Replace Mother Boardas per Kit Instructions

Unplug Stove