hercules water stops catalogue
DESCRIPTION
waterstopTRANSCRIPT
HERCULES ELASTOMERIC WATERSTOPS (HWS) SERIES
Waterstops System
HERCULES Engineering (SEA) Sdn Bhd
INTRODUCTION
The HERCULES Rubber waterstops are divided into
two types which are dumbbell & center bulb
shaped. The waterstops are designed for joints in
structures such as bridges & etc. Hercules Rubber
Water stops are formed or extruded as a
continuous piece. Any required intersection can be
cold or hot vulcanized as site joining requirement.
MATERIAL SPECIFICATION
HERCULES waterstops are formed or extruded
from High quality Natural Rubber (NR) or
Neoprene to suit the projects requirements. It shall
comply to the following materials physical
properties specification;
MATERIALS PHYSICAL PROPERTIES
The Elastomeric seal shall comply with the
following physical properties requirements;
Properties Requirements Test Method
Tensile Strength, Mpa 17 Mpa min. ASTM D412
Elongation at Break, % 450% min. Hardness, Shore ‘A’ 60±5 ASTM
D2240 Compression Set, (22hrs/70 ̊C), %
30 % max. ASTM D 395-89 Method B
Ozone Resistance (24hrs@23 C̊, 5% strain, 10ppm in air)
No Cracks ASTM D1149
Water Absorption (By Weight) 48hrs@70 C̊
5% max.
ASTM D471-98
INSTALLATION OF WATERSTOPS
HERCULES waterstops can be pre-vulcanized to the
required length and types of intersection prior to
installation at site. Anyway, hot & cold vulcanizing
can be performed at site if required.
HERCULES WATERSTOPS DIMENSIONS
HWS – DUMBBELL TYPE (DB)
Part No x, mm y, mm z, mm
HWS-
DB150 150 10 25.4
HWS-
DB230 230 10 25.4
HWS – CENTERBULB TYPE (CB)
Part
No
x,
mm
y,
mm
z,
mm
ID,
mm
OD,
mm
HWS-
CB150 150 10 25.4 16 29
HWS-
CB230 230 10 25.4 19 38
Please contact our sales representative
(+603 – 61566388) for special requirements.
z y
x
z y
x
ID OD