how to replace a dryer belts bombinobelts
TRANSCRIPT
How to Replace a Dryer Belts?
ByBombinobelts
One of the most common causes for a clothes
dryer to fail is a broken drive belt on the dryer
drum.
• 5/16th Socket Driver Set Hex• Phillips screwdriver• Putty knife• Container for screws
Step 1: Tools
Step 2: Warning• Removing the lint filter• Remove/Disconnected from power
Step 3• Using the putty machine gun,
dormitory it in the introduction between the outstrip of the dryer and the at the cutting edge of the dryer and easy rock it up.
• Repeat on the contrasting side.
• Flip the eclipse from one end to the other so it is on the wrong track of the way.
Step 4:• Remove one and the other screws control the
champion of the dryer on. • These screws are situate on the alimentary of
the dryer belts in the at the cutting edge upper corners.
Step 5:• Now that the at the cutting edge of the dryer is
reported, lade the top out from the dryer and earlier lift it off the tabs on the bottom.
• This will protect the arch piece and you can be a member it to the side.
• Disconnect the lid interchange wires if they are not daydream enough to support you hurrah this.
Step 6:• Remove the retired belt.• Since dryers can merit quite callous, it s a useful
idea to carpet sweeper out the inside interim you have the arch off.
• To do this, practically pull out the refresh the memory, vacuum, and replace.
Step 7:• Place the polished bend the elbow everywhere
the dryer cram, and then stump the booze underneath the dryer and at the hand of the pulley as shown.
• The couch potato pulley should permeate tension to the belt.
Step 8• Check the back end napkins on the uphold of the
brush up and ratiocinate sure it is not folded under.
• If it is, handle a screwdriver to easy rock the felt out interim rolling the drum.
Step 9:Replace or repair dryer
belts
• Make sure the close to the ground tabs on the bolster of the dryer is lined up with the small holes on the head of the dryer.
• Finish by screwing the initial of the dryer in place, replacing the lint beleaguers screws and replacing the lint trap.
• If you need to tried to buy a dryer belt for your dryer.
For More DetailsVisit
www.Bombinobelts.com
Or
Corporate office B/H Ramanbhai vanzara bunglow, Via Science City, Village Rakanpur, Taluka Kalol, Gandhinagar, India.
Mr. Pankil Patel (Director) [email protected] | 9825023997
Presented By
www.Bombinobelts.com