introduction to advanced design system (ads) by …braaten/intro_to_ads.pdfintroduction to advanced...
TRANSCRIPT
Introduction to Advanced Design System (ADS) by Agilent
Technologies
Benjamin Braaten
ECE Department
North Dakota State University
Starting ADS
Starting ADS – click “Create a new project”
Starting ADS – type in the title of the project and click “OK”.
Make sure the project name ends in “_prj”!
Starting ADS – After clicking “OK” you will get the following screen. Press “cancel” and
close the “Schematic” window.
Starting ADS – This will leave the following window.
Starting ADS – Next, under “window” click “new layout” to open Momentum.
Starting ADS – This will open the following windows
Bigger image
For this example we will simulate the following filter:
Substrate: grounded FR4Permittivity = 4.25
Loss Tangent = .003Thickness = 1.76 mm
LayoutFirst define the substrate
Opens the followingwindow
Define the substrateproperties in thiswindow
Layoutdefine the layout layers
Next, define the layout layers
Click “strip” when adding layer up here
Click “OK” when finished
LayoutNow insert a trace
Define a 3.34 mm trace width here.
LayoutClick on screen
once to start here
Press the space bar to
end here.
20 mm long
LayoutIn a similar manner, draw the filter.
LayoutNext, define the source.
Click “OK”
LayoutNext, define the source position.
Define port positionand left click tosnap to conductor.
Do the same for both sides.
LayoutNext, define the source properties.
Define the portproperties here.
Press to start simulation
When the simulation is done the following window will open:
Marker command
Enjoy ADS!