JUICERINSTRUCTION MANUAL

JE6008-UL

JUICER

INSTRUCTION MANUAL

Model: JE6008-UL

Read this booklet thoroughly before using and save it for futurereference

IMPORTANT SAFEGUARDSWhen using the electrical appliance, the below basic safetyprecautions should be followed:1. Read all instructions.2. Before using check that the voltage power corresponds to the

one shown on the appliance nameplate.3. Do not operate any appliance with a damage cord or plug or after

the appliance malfunction or has been damaged in any manner.Return the appliance to the nearest authorized service facility forexamination, repair or adjustment.

4. The use of attachment, including sieve, top lid, food pusher, jarnot recommended or sold by manufacture may cause fire,electric shock or injury.

5. Do not place on or near a hot gas or electric burner or in aheated oven.

6. Do not let cord hang over edge of table or counter.7. Never run the appliance under no food condition.8. Do not use the appliance if the rotating sieve is damaged.9. Do not put your fingers or other objects into the juicer opening

while it is in operation. If food becomes lodged in opening, usefood pusher or another piece of fruit or vegetable to push it down.When this method is not possible, turn the motor off anddisassemble juicer to remove the remaining food.

10. Do not push the food with hand, spoon, chopstick and clip etc.other than food pusher into the jar lid when the appliance isconnected to power source.

11. Always make sure juicer cover is clamped securely in placebefore motor is turned on. Do not unfasten clamps while juicer isin operation.

12. Sharp Blade-Always use food pusher.13. Avoid contacting moving parts.14. For the juicer, make sure the switch is on “O” position after each

use of your juicer. Make sure the motor stops completely beforedisassembling.

15. Do not immerse the Motor Unit into water or other liquids.16. All detachable parts must be dry completely after cleaning, and

then assemble them into appliance for next using.17. Close supervision is necessary when any appliance is used by or

near children.18. Warn of potential injury from misuse.19. If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified persons inorder to avoid a hazard.

20. Switch off the appliance and disconnect from supply beforechanging accessories or approaching parts that move in use.

21. Always disconnect the juicer from the supply if it is leftunattended and before assembling, disassembling or cleaning.

22. This appliance shall not be used by children. Keep the applianceand its cord out of reach of children.

23. Appliances can be used by persons with reduced physical,sensory or mental capabilities or lack of experience andknowledge if they have been given supervision or instructionconcerning use of the appliance in a safe way and if theyunderstand the hazards involved.

24. Children shall not play with the appliance.25. Do not use outdoors.26. Save these instructions.

HOUSEHOLD USE ONLY

KNOW YOUR JUICER

Small cleaning brush

Food pusher

Grinding head Jam strainer (with large mesh)

Juice container

Juice outlet

Jar

Residue container

Residue outlet Juice outlet cover

Power switch

Jar lid

Fastener

Motor unit

Juice strainer (with small mesh)

Frozen dish strainer

FUNCTION DESCRIPTIONThe low speed juicing juicer is a unique system where fresh juicecomes from squeezing rather than grinding. The slow juicer squeezesinstead of grinding which allows the juice to maintain its pure color,natural taste, nutrients and vitamins. The juice will flow in your juicecup from the juice spout, and the pulp will be ejected from pulpejection spout and be collected by pulp container. When using thejuicer, the pulp container and juice container must be assembled inposition. The details will be described in the following.

FOR THE INITIAL USE1. Unpack the appliance and place all parts on a horizontal surface.2. Immerse all the detachable parts and accessories in warm soapywater and rinse them and dry. But never immerse motor unit in waterfor cleaning to prevent the risk of electric shock.3. The correct assembly way will be described for details in belowsections.Before assembling, be sure the power cord is unplugged fromthe power outlet and the power switch is on the “O” position.

NOTES BEFORE USE1） Prepare all the required materials according to the

characteristics of them- Materials with hard fibreThe materials with hard fibre shall be cut into slices 3~5cm in lengthand 1.5~2cm in thickness.- Leaf vegetables and materials with long & hard fibre (such as celery,wildcelery herb and collard etc.)Cut the stems of the materials into slices 3~5cm in length and thenroll up the leaves of the materials well.- The fruit with hard core shall be pitted. The cores of peach, plum,mango, apricot and jujube shall not put into the jar lid to avoid anymalfunction.- The materials with thick or hard peel shall be peeled before beingput into the juicer for processing.- The frozen materials can just be used after being defrosted. Neveruse ice.- Never process the materials with high vegetable oil or animal oilwith this juicer to avoid the degradation and damage of the grindinghead

2) For frozen dish strainer, the following notes must be followedwhen operate:-The frozen dish strainer can only be used for making frozen dishwith deeply-frozen banana or banana & blueberry. Before process,defrost the frozen materials into a condition that a fork can insert intothe center of them.-Feed materials little by little every approximately 5 seconds.-Do not process the materials having not be defrosted.-Do not push the materials into the jar lid with excessive force.-The frozen dish strainer can not be replaced by juice strainer or jamstrainer when operate.3) Never put sugarcane, coconut, kudzu or cereal (e.g. bean, rice)without being soaked with water into this juicer for processing.4) Do not put overmuch materials in the juicer each time, therefore,the materials with less moisture and hard fibre shall be put into the jarlid after being cut into slices.5) Do not put overmuch materials in the juicer each time, therefore,the materials with less moisture and hard fibre shall be put into the jarlid after being cut into slices.6) Assemble the buffer plate well in positionThe buffer plate shall be assembled well in the residue outlet afterfinish cleaning each time.

ASSEMBLE YOUR SLOW JUICER1. Put the jar downwards and make sure that the residue outlet shallbe placed well in position. The jar shall be assembled well in positionproperly otherwise the appliance will not operate. Besides, beforeoperating, please check the buffer plate and make sure that it mustbe assembled well in the residue outlet (See Fig.2).

Fig.1 Fig.22. Then select the strainer based on your demand and then put itinto the jar. There are three strainers including juice strainer, jamstrainer and frozen dish strainer for your selection. After it, put thegrinding head into the jar and ensure the grinding head is coveredwell into the axis of the motor unit (see Fig.3).NOTE: The three strainers including juice strainer, jam strainer andfrozen dish strainer can not be exchanged with each other whenoperate. Juice strainer is used for extracting juice, jam strainer isused for making ketchup only while frozen dish strainer is used formaking frozen dish. Select the appropriate strainer based on yourdemand.

Fig.3

Buffer plate Buffer plate

3. Assemble the jar lid on the jar correctly. Firstly, put the jar liddownwards and then make the symbol “ ” on the jar lid align with

the symbol “ ” on the jar and then rotate the jar lid clockwise until

the symbol “ ” on the jar lid aligns with the symbol “ ” on the jar

(See Fig.4). After it, press the fastener inwards to lock the jar lid wellin position. The jar lid shall be assembled well in position properlyotherwise the appliance will not operate. Finally, put the food pusherinto the jar lid.

Fig.4

4. Place your juice container below the juiceoutlet and residue container below the residueoutlet (see Fig.5). Until now, the Juicer is readyfor operating.Note: When need to remove the wholeappliance, please grasp the motor unit instead ofthe jar lid to remove it to avoid accident.

Fig.5

USING YOUR JUICER1. Before attaching the power cord into the outlet, make sure thepower switch is in the “O” position, the power switch has threesettings: “I” indicates “ON”, press the power switch to “I” position toactivate the motor and start making juice; “O” indicates “OFF”position, press the power switch to “O” position to turn off themachine; “R” means reverse rotation, which is only used whensomething is stuck and you need to unclog.2. Make sure the juice container and the residue container are placedin position.3. Cut fruits and vegetables into smaller pieces. For example, thecarrots shall be cut into thin slices with size of 15mm×15mmbefore being put into the machine.NOTE:A) Please remove any hard seeds before juicing.B) It is forbidden to process coconuts, sugarcane or similar hardfoodstuffs, since this may damage the motor.

C）It is not recommended to process hard fruit or vegetable rich

in fiber and starch.D) The peel and pits should be removed from oranges, lemons,grapefruits and melons.4. Drop the prepared fruits or vegetables into the jar lid at an evenspeed and then let the fruits or vegetables drop into the grinding headautomatically. Do not load food too fast and do not load too muchfood at a time.Note: Use the food pusher to remove the blockage if the jar lid isblocked by the materials.5. Connect the appliance to the power source, and then press thepower switch to the“ON”position, the appliance starts to work. After afew minutes, the juice flow out.Caution: Do not turn the power switch from "I" to "R" or from"R" to "I" directly at any time during operation. If required, firstly

press the power switch to “O” position and make the appliancestop running completely and then turn the power switch from "I"to "R" or from "R" to "I" .Caution: Do not operate the unit before feeding food to avoiddamaging the grinding assembly (include grinding head andstrainer).Caution: Do not put your fingers or other foreign objects into the

feeding opening while it is in

operation.6. During operation, if the machineis stuck and not operable, pleasefirstly press the power switch to “O” position and then press the resetswitch which is equipped at the bottom of appliance (see Fig.6). Afterit, press and hold the power switch to the “R” position for few secondsthen try operating again. When reverse function cannot work, turn offthe machine and reassemble following the instructions given. Afterreassembly please try turning on the machine.7. When the juice container is full (the max capacity is 400ml) or thefood has been finished extracting, turn the power switch to the “O”position and empty the juice container and residue container beforecontinuing extracting.Note: The max operation time per time shall be less than 15minutes. Minimum 30 minutes rest time must be maintainedbetween continuous two cycles.Note: Do not insert too much food to extract per time. Duringoperation, once the juice container is full, you must stop theappliance and empty the residue container before next cycle.Note: During operation, if the interlock switch between the jar lidand the motor unit is disconnected, the motor will stop toprevent from danger.Note: When extract juice, the residue must be removed as soonas possible so that the jar, grinding head and jar lid can be

Fig.6

Reset switch

detached easily.8. After finish, enjoy your juice in time for best taste. Any unused juiceshould be stored in the refrigerator.

CLEANING AND MAINTENANCE1. Unplug the appliance and wait it completely cool down beforecleaning.2. In order to detach & clean more easily, plug in and run the juicerwithout load for about 30 seconds after removing the residue. If thejar lid cannot be detached easily, please follow and repeat thefollowing operation for two or three times: Reverse—OFF—ON, at thesame time, hold and rotate the jar lid to detach it. After finishextracting juice, pour some water into the jar lid to clean it so that itwill be easier to be detached.Caution: Do not turn the power switch from "I" to "R" or from"R" to "I" directly at any time during operation. If required, firstlypress the power switch to “O” position and make the appliancestop running completely and then turn the power switch from "I"to "R" or from "R" to "I" .3. Remove the food pusher, then push the fastener outwards torelease the jar lid, after it, turn the jar lid anti-clockwise to remove it.4. Detach the strainer and grinding head from the jar. If it is difficult todetach the grinding head, put the jar on the working table and holdthe grinding head with a hand, then push the axis of grinding head(see Fig.7) at the jar bottom withanother hand to push the grinding headout of the jar.5. Empty the residue container, andthen clean the jar lid, grinding head,strainer, jar and residue container under running water. Whencleaning the strainer, only need to brush the concave surface of thestrainer under running water with the small cleaning brush for several

Fig.7

Axis of grinding head

times, and then the whole strainer can be cleaned well.Caution: Strainer is sharp, so handle carefully during cleaningCaution: Do not use metal sponge to clean, it will damage themachine.6. If you need to clean the residue outlet thoroughly, you shall firstlypull the buffer plate out of the residue outlet and then clean itcompletely with the small cleaning brush.7. Wipe the outside of motor unit with damp cloth. Never immerse themotor unit in water.8. Dry all parts and assemble all parts well and then store theappliance in a dry place. The juice container can be stored in theresidue container.

RECIPES