CONVENTIONSOFDRAFTING

BuildingconstructionSemester1

LECTURE PREPARED BY FACULTY: DEEPIKA SHETTY

Draw the border and tittle block as follows for an A2 size sheet:

Note:Border 1.5cm on top, bottom and right sides2.5 cm on the left sideTittle block as shown in the fig.

DRAWING NO:2ADRAWING TITTLE: LETTERING

EACH ALPHABET IS IN A RECTANGLE OF HEIGHT 15MM AND WIDTH 12MM. THE SPACING OF THE RECTANGLE CAN BE AROUND 4-5MM.WRITE ALPHABETS AS SHOWN IN A SHEET OF A2 SIZE AND DRAW FORMAT AND TITTLE BLOCK AS GIVEN PRVIOUSLY.THE WORDS DETAILS AND MATERIALS WILL NOT FOLLOW THE SPACING OF 4-5MM.

DRAWING NO:2BDRAWING TITTLE: LINE TYPES AND MATERIAL HATCH

DRAW A COLUMN OF 10CM TO THE LEFT FOR THE LABELLING AS SHOWN .DRAW THE LINE TYPES HORIZONTALLY FROM RIGHT BORDER TO LEFT BORDER ON THE REST OF THE SHEET

DRAWING NO:2CDRAWING TITTLE: SYMBOLS

References:1. Prabhu Balagopal T.S.,Paul Vincent K., Vijayan C., Building design and

civil engineering drawing (1999), Spades Publishers and Distributers, Calicut.

2. Shah M.G., Kale C. M., Patki S. Y., Building Drawing(2nd edition), Tata McGraw-Hill Publishing Company, New Delhi.

3. IS 962, 1959, reaffirmed 2001, Code of Practice for Architecture and Building Drawing second revision reprint 1993, Bureau of Indian Standards, New Delhi.

4. SP46, 1988r, Engineering drawing practice for schools and colleges, reprint 1988, Bureau of Indian Standards, New Delhi.

5. Ching Francis D.K., Architectural Graphics, 3rd edition, 1996, Van Nostrand Reinhold, USA.