Lock and Roll Up Tonneau Cover

Installation GuideParts included in the Assembly:

Item

RA

RB

RC

RD

RE

RF

RG

RH

Description

Tonneau Tarp, with Front Bar and Rear Bar ..............

Left Side Rail ...................................................................

Right Sde Rail ..................................................................

Front Crossbow ..............................................................

Central Crossbow ...........................................................

Rear Crossbow ...............................................................

Clamp Assembly .............................................................

Adjustable Setting Knob ................................................

Qty

1

1

1

1

1

1

6

2

Required Tools:1 Allen Wrench 3/16”, Measuring Tape

STEP

1STEP

2

Check contents of carton with the list above

Place the right side rail (Item RC) and left side rail (Item RB) on each side of the truck bed.

Lock and Roll Up Tonneau Cover

Installation GuideSTEP

3Insert the clamps (Item RG) inside the side rail inner groves. Distribute the clamps evenly on each side of the cover (see picture). Loosely tighten the clamps with the Allen wrench

STEP

4Insert front bar (item RA) into the 2 side rails (item RB and RC), and tighten the knobs (RH). (Pay attention to the position of the knobs in the picture bellow)

Lock and Roll Up Tonneau Cover

Installation GuideSTEP

5Measure the length between the outside of the 2 metal locking tongues (The metal locking tongue is on each side of rear bar), record the length.

STEP

6Adjust the distance between 2 side rails on the truck bed, make sure the distance between the 2 locking bases is adjusted to the same length as the result of Step 5. (The locking base is on the rear end of the side rail)

Lock and Roll Up Tonneau Cover

Installation GuideSTEP

7Then tighten the clamps tightly on the side rails with the allen wrench.

STEP

8Insert the cover crossbows (Item RD, RE, RF) in the groves of the side rails, as in the picture bellow. Position of the bows is defined by cut-outs in the rail

NOTE: Bows may have different lengths. In this case, put the longest one on the front, and shortest on on the rear.

Lock and Roll Up Tonneau Cover

Installation GuideSTEP

9Pull the tonneau tarp, push down the rear bar, close and lock the rear bar.

STEP

10Insert the plastic extrusion on the tonneua tarp into the outside grove of each side rail.

STEP

11To open the cover, open the truck bed tailgate, pull the handle in the middle of the cover rear bar, unlock the bar, roll up the whole cover to the front of the truck bed, then use the buckles to secure the rolled tarp.

NOTE: When pushing down the rear bar, DO NOT push the center of the bar. Push on each end of the bar, until the lock pin (lock tongue) is locked completely in the side rail locking house (lock base).

Lock and Roll Up Tonneau Cover

Installation GuideFor Nissan/Toyota Trucks (with Utility Track channel) only

Place the frame (RB,RC) on the bed, and insert the clamps (item 8-A) inside the side rail (RB,RC) inner groves.

Distribute the clamps evenly on each side of the cover. Tighten the hex nut (item 8-B) on clamps.

Slide the aluminum block (item 8-C) in the truck bed factory track, and tighten the aluminum block and clamps with the allen wrench. (see pictures)

The Item RG (clamp assembly) will become a bracket set as in below photo (Item 8-A,B,C). Follow bellow steps to assemble the side rails (RB,RC) on the truck bed:

WARNING-CARE OF THE COVER TARP:

Do not use cleaners or detergents onplastic. Clean the tarp with neutral soapand water.

When closing the cover, make sure the rear bar is locked firmly, and the side plastic extrusion is inserted into the side rail completely. Do not travel unless the cover is properly locked.