lofting boss, cut, or surface. - fern ridge school … · lofting lofting creates a ... boss, cut,...
TRANSCRIPT
80
EXERCISE 8 Lofting
Lofting creates a feature by making transitions between profiles. A loft can be a base,
boss, cut, or surface.
1. Create four (4) planes beginning from the “XY Front” plane and offset from
each other as shown. Plane 1 – 6.00” Plane 2 – 8.00” Plane 3 – 1.00”
2. Sketch 1 on the “XY Front” plane should look like this… use the Spline tool.
Objective: Create a boat hull by lofting multiple section profiles.
81
3. Sketch 2 on “Plane 1” should look like this…
4. Sketch 3 on “Plane 2” should look like this…
5. Sketch 4 on “Plane 3” should point at the origin.
82
7. Loft: Exit any sketches and select Loft.
8. Profiles: Select the four profiles in order from back to front of boat.
83
9. Use the Mirror feature and select the flat side face as the plane to mirror from.
10. Select the hull as the feature and hit OK to apply.