longitudinally segmented shashlik calorimeters with ... · m. pozzato (infn-bologna) on behalf of...

1
Longitudinally segmented shashlik calorimeters with embedded SiPM readout for the ENUBET Project Prepared by M. Pozzato, (INFN-Bologna, [email protected]) for the “IFAE XVI Incontri di Fisica delle Alte Energie” – Trieste 19 th 21 st April 2017 M. Pozzato (INFN-Bologna) on behalf of ENUBET collaboration ENUBET (Enhanced NeUtrino BEams from kaon Tagging) is a ERC Consolidator Grant-2015 project (n° 681647, P.I. A. Longhin) with a 2 MEUR funding started on 1/6/2016 w. a 5 years duration A new-concept ν e source based on tagging of e + from K + e + 0 e decays The goal of the project is to demonstrate the feasibility of real time monitoring of the positrons produced at high angle in the decay tunnel of conventional neutrino beam to obtain a x 10 reduction in the systematics on the neutrino flux Highly beneficial for the leptonic CP violation international program at long baselines ( e ). Hadron beam-line Neutrino detector K/p protons K + decay e + e Hadron beam-line: collects, focuses, transports K + to the e + tagger e + tagger: real-time, ''inclusive'' monitoring of produced e + particle rates: > 200 kHz/cm 2 backgrounds: pions from K + decays extended source of ~ 50 m spread in the initial direction Tagger challenges Technological challenges Radiation hard components: harsh environment Readout system: embedded in the calorimeter bulk Recovery time: O(10ns) Readout in triggerless mode: long extraction (10 ms) Degassing: detector inside the beam-pipe Scalable /cheap technology: up to 210 5 channels The Ultra-Compact Module (UCM) 1 SiPM WLS fiber 9 SiPM signals are added No WLS bundling Optimal homogenity in longitudinal sampling t 0 - Layer Shashlik Calorimeters for Electron Neutrino T agging and T racing Testbeams @ CERN-PS T9 July/November 2016: SCENTT Sensitivity to M.I.P UCM auto-calibration viable No saturation effect for e.m. showers up to 5 GeV 56 e.m. + 18 adronic UCMs 30 X 0 e/ separation study t 0 layer R&D Uniformity first test: direct coupling SiPM-scintillator Time response SiPM SenSL 30020 Series J Directly pulsed with Picosecond Laser ( = 405 nm) Electrons tagged by Cherenkov counters s Polysiloxane scintillator R&D: INFN-PD and LNL (S. Carturan) No drilling/molding of tiles First time Test in HEP @T9 November 16 th New prototype under development: Light Yield maximization Collection efficiency improvement [1] “A novel technique for the measurement of the electron neutrino cross sectionA. Longhin, L. Ludovici, F. Terranova Eur. Phys. J. C (2015) 75:155 [2] Enabling precise measurements of flux in accelerator neutrino beams: the ENUBET project” The ENUBET collaboration CERN-SPSC-2016-036; SPSC-EOI-014 [3] “A compact light readout system for longitudinally segmented shashlik calorimetersA. Berra et al. N.I.M. A, 2016.05.123 arXiv:1605:09630 References http://enubet.pd.infn.it

Upload: others

Post on 30-Mar-2021

1 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: Longitudinally segmented shashlik calorimeters with ... · M. Pozzato (INFN-Bologna) on behalf of ENUBET collaboration ENUBET (Enhanced NeUtrino BEams from kaon Tagging) is a ERC

Longitudinally segmented shashlik calorimeters with embedded SiPM readout for the ENUBET Project

Prepared by M. Pozzato, (INFN-Bologna, [email protected]) for the “IFAE XVI Incontri di Fisica delle Alte Energie” – Trieste 19th – 21st April 2017

M. Pozzato (INFN-Bologna) on behalf of ENUBET collaboration

ENUBET (Enhanced NeUtrino BEams from kaon Tagging) is a ERC Consolidator Grant-2015 project (n° 681647, P.I. A. Longhin) with a 2 MEUR funding started on 1/6/2016 w. a 5 years duration

A new-concept νe source based on tagging of e+ from K+ e+0e decays

The goal of the project is to demonstrate the feasibility of real time monitoring of the positrons produced at high angle in the decay tunnel of conventional neutrino beam to obtain a x 10 reduction in the systematics on the neutrino flux → Highly beneficial for the leptonic CP violation international program at long baselines (→e).

Hadron beam-line Neutrino detector

K/p

protons

K+ decay

e+ e

Hadron beam-line: collects, focuses, transports K+ to the e+ tagger e+ tagger: real-time, ''inclusive'' monitoring of produced e+

particle rates: > 200 kHz/cm2

backgrounds: pions from K+ decays extended source of ~ 50 m

spread in the initial direction

Tagger challenges

Technological challenges

Radiation hard components: harsh environment Readout system: embedded in the calorimeter bulk Recovery time: O(10ns)

Readout in triggerless mode: long extraction (10 ms) Degassing: detector inside the beam-pipe

Scalable /cheap technology: up to 2105 channels

The Ultra-Compact Module (UCM)

1 SiPM WLS fiber 9 SiPM signals are

added No WLS bundling Optimal homogenity in

longitudinal sampling

t0 - Layer

Shashlik Calorimeters for Electron Neutrino Tagging and Tracing

Testbeams @ CERN-PS T9 July/November 2016: SCENTT

Sensitivity to M.I.P UCM auto-calibration viable No saturation effect for e.m. showers up to 5 GeV

56 e.m. + 18 adronic UCMs 30 X0 e/ separation study

t0 layer R&D Uniformity first test: direct coupling SiPM-scintillator

Time response SiPM SenSL 30020 Series J

Directly pulsed with Picosecond Laser ( = 405 nm)

Electrons tagged by Cherenkov counters s

Polysiloxane scintillator R&D: INFN-PD and LNL (S. Carturan)

No drilling/molding of tiles First time Test in HEP

@T9 November 16th

New prototype under development:

Light Yield maximization Collection efficiency improvement

[1] “A novel technique for the measurement of the electron

neutrino cross section” A. Longhin, L. Ludovici, F. Terranova

Eur. Phys. J. C (2015) 75:155

[2] “Enabling precise measurements of flux in accelerator

neutrino beams: the ENUBET project” The ENUBET

collaboration CERN-SPSC-2016-036; SPSC-EOI-014

[3] “A compact light readout system for longitudinally

segmented shashlik calorimeters” A. Berra et al. N.I.M. A,

2016.05.123 arXiv:1605:09630

References

http://enubet.pd.infn.it