1

2

BIOS SETUP UTILITY

Main Smart H/W Monitor Boot Security ExitAdvanced

Use [Enter], [TAB]or [SHIFT-TAB] toselect a field.

Use [+] or [-] toconfigure system Time.

Select ScreenSelect Item

+- Change FieldTab Select FieldF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

System Overview

System Time

System Date[ :00:09][Wed 06/24/2009]

BIOS VersionProcessor Type

Processor SpeedMicrocode UpdateL1 Cache SizeL2 Cache Size

Total Memory

DDRII_A1DDRII_A2

L3 Cache Size

DDRII_B1DDRII_B2

: M3A770DE P1.00: AMD Phenom(tm) II X3 720

Processor (64bit): 2800MHz: 100F42/1000086: 384KB: 1536KB: 6144KB

: 2048MBSingle-Channel Memory Mode

: None: None: None: 2048MB/667MHz (DDR3 1333)

17

BIOS SETUP UTILITY

Main Advanced H/W Monitor Boot Security Exit

Smart Settings Exit system setupafter saving thechanges.

F10 key can be usedfor this operation.

Select ScreenSelect Item

Enter Go to Sub ScreenF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

Smart

Save Changes and Exit

Load BIOS DefaultsLoad Performance Setup Default (IDE/SATA)Load Performance Setup AHCI ModeLoad Performance Setup RAID ModeLoad Power Saving Setup Default

BIOS Update Utility

ASRock Instant Flash

3

4

BIOS SETUP UTILITY

Main Smart H/W Monitor Boot Security Exit

Select ScreenSelect Item

Enter Go to Sub ScreenF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

Advanced

Advanced Settings

WARNING : Setting wrong values in below sectionsmay cause system to malfunction.

CPU ConfigurationMemory Configuration

ACPI ConfigurationChipset Configuration

Storage ConfigurationPCIPnP ConfigurationFloppy ConfigurationSuperIO ConfigurationUSB Configuration

Options for CPU

5

BIOS SETUP UTILITY

CPU Configuration

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Advanced

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

CPU Frequency (MHz)PCIE Frequency (MHz)

Overclock Mode[200][100]

[Auto]

Spread Spectrum

Enhanced Halt StateL3 Cache AllocationAdvanced Clock Calibration

Boot Failure GuardCool' n' QuietSecure Virtual Machine

Processor Maximum FrequencyNorth BridgeProcessor Maximum Voltage

Maximum Frequency

HT Bus SpeedHT Bus Width

[Auto][Auto]

x10.5 2100 MHZx9.0 181.2500 V

00 MHz

[Auto][Enabled][Auto][Enabled][Disabled][Auto][Disabled]

Multiplier/Voltage Change [Auto]

Select the over clockmode.

6

BIOS SETUP UTILITY

CPU Configuration

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Advanced

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

CPU Frequency (MHz)PCIE Frequency (MHz)

Overclock Mode[200][100]

[Auto]

Spread Spectrum

Enhanced Halt StateL3 Cache AllocationAdvanced Clock Calibration

Boot Failure GuardCool' n' QuietSecure Virtual Machine

[Auto][Enabled][Auto][Enabled][Disabled][Auto][Disabled]

Select the over clockmode.

Processor Maximum FrequencyNorth BridgeProcessor Maximum Voltage

Maximum Frequencyx10.5 2100 MHZx9.0 1800 MHz1.2500 V

Multiplier/Voltage Change [Manual]Processor Target FrequencyNorth Bridge Target Frequency

x10.5 2100 MHZx9.0 1800 MHz

7

8

BIOS SETUP UTILITY

Memory Configuration

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Advanced

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

Memory Controller ModePower Down EnableBank InterleavingChannel Interleaving

[Unganged][Disabled][Auto][XOR of Address bit]

Memory Clock [Auto]

Timing : 4-4-4-12

Timing : 2-2-2-4-16

CAS Latency (CL)TRCDTRPTRAS

TRTPTRRDTWTRTWR

[Auto][Auto][Auto][Auto]

[Auto][Auto][Auto][Auto]

9

10

11

12

BIOS SETUP UTILITY

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Chipset Settings

Onboard HD AudioFront Panel

OnBoard LanGraphics AdapterPrimary [PCI]

[Auto][Auto][Enabled]

Select ScreenSelect Item

+ - Change OptionF1 General Help

F10 Save and ExitESC Exit

F9 Load Defaults

Advanced

DRAM Voltage [Auto]

To set DRAM Voltage.

13

BIOS SETUP UTILITY

ACPI Settings Select auto-detect ordisable the STRfeature.

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Advanced

Suspend To RAM

Away Mode Support

Restore on AC / Power LossRing-In Power OnPCI Devices Power OnPS / 2 Keyboard Power OnRTC Alarm Power On

ACPI HPET Table

[Disabled]

[Disabled]

[Power Off][Disabled][Disabled][Disabled][Disabled]

[Disabled]

14

BIOS SETUP UTILITY

Storage Configuration

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Advanced

Onboard SATA Controller

SATA Operation Mode

IDE1 MasterIDE1 SlaveSATAII_1SATAII_2SATAII_3SATAII_4SATAII_5SATAII_6

[Enabled]

[IDE]

[Hard Disk][Not Detected][Not Detected][Not Detected][Not Detected][Not Detected][Not Detected][Not Detected]

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

Configure onboardserial ATAcontroller.

BIOS SETUP UTILITY

IDE Master Select the typeof device connectedto the system.

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Advanced

Type

LBA/Large ModeBlock (Multi-Sector Transfer)PIO ModeDMA ModeS . M . A . R . T .32Bit Data Transfer

[Auto]

[Auto][Auto][Auto][Auto][Disabled][Disabled]

DeviceVendorSizeLBA ModeBlock ModePIO ModeAsync DMAUltra DMAS.M.A.R.T.

:Hard Disk:MAXTOR 6L080J4:80.0 GB:Supported:16Sectors:4:MultiWord DMA-2:Ultra DMA-6:Supported

15

16

BIOS SETUP UTILITY

Advanced PCI / PnP Settings Value in units of PCIclocks for PCI devicelatency timerregister.

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

PCI Latency TimerPCI IDE BusMaster

[32][Enabled]

Advanced

BIOS SETUP UTILITY

Floppy Configuration Select the type offloppy driveconnected to thesystem.

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Advanced

Floppy A [1.44 MB 3 "]12

17

BIOS SETUP UTILITY

Configure Super IO Chipset Allow BIOS to Enableor Disable FloppyController.

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Advanced

OnBoard Floppy ControllerSerial Port AddressInfrared Port Address

[Enabled][3F8 / IRQ4][Disabled]

18

BIOS SETUP UTILITY

USB Configuration To enable or disablethe onboard USBcontrollers.

Select ScreenSelect Item

+- Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Advanced

USB Controller

USB 2.0 SupportLegacy USB Support

[Enabled]

[Enabled][Enabled]

19

BIOS SETUP UTILITY

Hardware Health Event Monitoring

Select ScreenSelect Item

F1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

CPU TemperatureM / B Temperature

CPU Fan SpeedChassis Fan SpeedPower

Vcore+ 3.30V+ 5.00V+ 12.00V

Fan Speed

: 37 C / 98 F

: 3400 RPM

: 1.629V: 3.306V: 5.067V: 11.890V

: 31 C / 87 F

: 3399 RPM: 3288 RPM

Main Smart Advanced Boot Security ExitH/W Monitor

Enable/DisableCPU Quiet FanFunction.

CPU Quiet Fan [Disabled]

20

BIOS SETUP UTILITY

Main Smart Advanced H/W Monitor Security Exit

Boot SettingsConfigure Settingsduring System Boot.

Select ScreenSelect Item

Enter Go to Sub ScreenF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

Boot

Boot Settings Configuration

1st Boot Device2nd Boot Device3rd Boot Device4th Boot Device

Hard Disk DrivesRemovable DrivesCD/DVD Drives

[1st Floppy Device][HDD: PM - HDS722580VL][CD / DVD: 3S - CD - ROM C][USB]

BIOS SETUP UTILITY

Boot Settings ConfigurationDisabled: Displaysnormal POST messages.Enabled: Displays OEMLogo instead of POSTmessages.

Select ScreenSelect Item

+ - Change OptionF1 General HelpF9 Load DefaultsF10 Save and ExitESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Boot

AddOn ROM DisplayBoot Logo

Boot From Onboard LANBootup Num-Lock

[Enabled][Auto][Disabled][On]

Full Screen Logo [Enabled]

21

BIOS SETUP UTILITY

Main Smart Advanced H/W Monitor Boot Exit

Install or Change thepassword.

Select ScreenSelect Item

Enter ChangeF1 General Help

F10 Save and ExitESC Exit

F9 Load Defaults

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

Security

Change Supervisor Password

Change User Password

Security Settings

Supervisor Password : Not InstalledUser Password : Not Installed

22

BIOS SETUP UTILITY

Main Smart Advanced H/W Monitor Boot Security

Exit system setupafter saving thechanges.

F10 key can be usedfor this operation.

Select ScreenSelect Item

Enter Go to Sub ScreenF1 General Help

F10 Save and ExitESC Exit

F9 Load Defaults

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

Exit

Save Changes and Exit

Discard Changes and ExitDiscard Changes

Exit Options

Would you like to save current settinguser defaults ?

Save 1st User Defaults

Save 2nd User Defaults

Save 3rd User Defaults

Load 1st User Defaults

Load 2nd User Defaults

Load 3rd User Defaults