operating instructions for the moonwalk - fun services of...

If Fun Services delivered your 7803 Meadow View Dr. Shawnee, KS 66

Moonwalk, we will set it up and take it down 913.441.9200 Fax 913.441.6396

Toll Free 800.477.9119

www.funservicesmidwest.com~ [email protected]

Operating instructions for the moonwalk START UP: Start the ride by plugging the fan into a 110-volt power supply (requires 20 amps). The fan must remain on during operation of the ride. Power supply must be within 100 feet of the outlet using a heavy-duty extension cord – 12 gauge minimum. RUNNING: Have all riders remove their shoes, eyeglasses and any items from their pockets. Keep like size people together. If it is an event where people are paying, everyone pays the same amount and pays before entering the moonwalk. LIMITS: Each moonwalk has manufacturer guidelines posted on the moonwalk for number of riders for appropriate age groups. (If not posted, or you have any questions, please call Fun Services®). KEEPING ORDER: People need to stay approximately two (2) feet away from the opening of the moonwalk. Do not allow anyone to hang on the netting (inside or out). Once or twice an hour, walk around the moonwalk to inspect that everything is in order. Make certain that all of the tie-downs are intact and that there are not rips or tears. RIDE TIME: Ride time is three (3) from the time that the last person enters the moonwalk. If there is a long line, reduce the time by 30 seconds or 1 minute. SHUT DOWN: When the event is over, make sure everyone is out of the moonwalk and then proceed to unplug the fan. (If Fun Services® delivered the Moonwalk, we will complete the tear down procedure.) See rolling instructions. RESTARTING: If the moonwalk begins to deflate, but you still have power, unplug the fan and reattach the tube to the fan and restore power. If the moonwalk begins to inflate due to the loss of power, check to make sure the cord is still plugged in to the power source and the fan, or if the circuit breaker needs to be reset. GENERAL: Moonwalk must be placed on a clean, solid, level surface away from obstructions. Make sure that debris is not stuck to the intake of the fan. Also check that the tube is free of any large kinks. FOLDING: Unplug, unhook tube from the fan, open zippers and/or vents. (Deflate time is approximately 10-15 minutes.) TROUBLE SHOOTING: If unit seems soft or spongy, check:

• For kinks in the air tube

• To make certain fans are plugged in and operating properly

• That all vents are closed If the unit has no power:

• Check the power source

• Check the circuit breaker (often the problem)



Toll Free 800.477.9119


Please call Fun Services® with any questions you may have to insure safe operations. On weekends or in case of emergency, please call Zach Wilson at 913.486.2680. Thank you!

SET UP The inflatable may weigh over 200lbs. Caution should be exercised when lifting and handling the equipment. Use a Dolly to move the equipment.

1. DO NOT set up when windy and or it rains Deflate unit if winds exceed 15 MPH. 2. Select a level area that is a safe distance from water, walls, and other obstructions. 3. Make certain that there are no overhead utility wires and ground obstacles such as

protruding sprinklers or underground pipes of any kind before laying the protective tarp on the selected area.

4. Place the inflatable in the middle of the tarp and unroll the unit after removing the straps 5. Connect either tube snugly (choose the one closest to the electricity source) to the blower

using the strap attached to the tube. Make sure that all intake openings of the blower are free from any obstruction



Toll Free 800.477.9119


6. Twist the vent (the other tube) several times, fold it over and secure snugly with the attached strap.

7. Approximately one foot form each tie down double-loop of the Moonwalk unit, drive an anchor to the ground at a 45 degree angle with the head pointing away from the moonwalk unit. Secure the moonwalk unit at all times to the corresponding number of anchors. Use the straps to attach the anchors to all the double-loops as provided in specific areas on the base of the moonwalk unit.

When the unit is on hard surface (cement, wood floors, etc.), substitute a sand bag with the adequate weight for the anchor.

8. Plug the blower into the closest properly grounded (GFCI) 110v outlet only after you

carefully read the blower manufacturer’s safety instructions. Turn the switch on and wait (approximately 2 minutes) until the inflatable is fully inflated and the equipment and all part have been examined for potentially unsafe conditions before letting children in the inflatable

9. This unit requires continuous air pressure. Do not turn the blower off while children are in the inflatable

DEFLATION PROCEDURES

1. Make sure there are no children inside or around the moonwalk unit before you turn the switch off and unplug the blower

2. Disconnect the air tube from the blower and untie the second air tube. Let both air tubes lie parallel to each other so the air can escape freely.

3. As the moonwalk unit deflates, arrange the columns to fall on top of the base making sure that the deflated unit is evenly spread out.



Toll Free 800.477.9119


4. Standing in front of the moonwalk unit (entrance), fold the left side and the right side so that

they meet in the middle and then fold one side over the other

5. Roll the moonwalk units toward the air tubes and then tuck the air tubes into the roll. 6. Secure the roll with each strap tied into a slipknot.



Toll Free 800.477.9119


7. Dolly the moonwalk unit into a dry area for storage.

Weather Warnings

1. Never operate any inflatable ride in winds that exceed 15 MPH.

2. Evacuate unit and deflate in winds over 15 MPH and or bad weather.

3.It is advisable to roll up the unit to keep rain out of the inside of the unit.

4. Use a weather app on your phone to keep track of weather, wind speed and other

possible issues while you have the unit inflated.

5.

operating instructions for the moonwalk - fun services of...

Documents