Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

PART DESIGN (DRAWING 06)

From this diagram we have to know,

Selection of plane

Drawing circle

Drawing rectangle

Pad the profile

Pocket definition

Offset plane

Symmetry constraint

Trimming

Object mirror

Chamfer

Fillet

Rotate options

Views

CATIA v5 software is used to modeling this object.

Prepared By

Veerapandian.K Mechanical Engineering.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

**WORKING STEPS**

Draw rectangle with dimensions.

Pad this with given dimensions.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Draw a circle. Locate this on position.

Pad this circle with mirror extend option.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Sketch rectangle as below pad this.

Again draw a rectangle at following place then pocket this.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Draw like this.

Give dimensions. Draw circle edit this with trim tool.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Pad the sketch.

Draw sketch like this.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Pad this sketch.

After pad diagram displays like this.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Draw circle then pad the circle.

Make hole inside the cylinder body.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Make a hole with hole definition option.

Mirror the object shown in diagram.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

Define edge fillet.

Define edge fillet.

Veerapandian.K MECHANICAL ENGINEERING, SRVEC, VEDARANYAM.

After completion the diagrams being like this.

Completed diagram.

Pandian.K