PINEAPPLE LED

TRIM LINE

SAFETY MARGIN

PINEAPPLE LED MANUAL

PRECISIONALLY CRAFTED

ALL GROW PHASES

• GERMINATION TO FULL MATURITY• 95+ CRI RATING

THE MOST ADVANCED ALL PHASE LIGHTING SOLUTION

ADVANCED OPTICAL DESIGN •HELPS DIRECT THE LIGHT INTO THE PLANTS FOR BETTER LIGHT PENETRATION AND EFFECTIVENESS

•THESE FIXTURES ARE DESIGNED TO PROVIDE HIGH YIELD AND QUALITY IN AN EFFICIENT RELIABLE, AND COST EFFECTIVE MANNER

IDEAL FOR INDOOR GROWERS WHO WOULD LIKE TO OPTIMIZE THE GROWTH RATE AND YIELD OF THEIR PLANTS, WHILE MINIMIZING ENERGY USAGE AND HEAT GENERATION

NECTAR SPECTRA• OPTIMIZED SPECTRUM PROMOTES FAST, HEALTHY PLANT GROWTH & DEVELOPMENT

• SWITCHES ALLOW CHANGE OF SPECTRUM & INTENSITY AS PLANTS TRANSITION FROM VEG TO FLOWER

AVAILABLE IN 120W, 300W, & 480W

HIGH EFFICACY CONVERTS MORE ELECTRICITY INTO PAR ENERGY FOR THE PLANTS, GENERATING OVER 2 umol/ Joule at the system level (Not just the LEDrating).

HIGH POWER LED LIGHTING PROVIDES THE ENERGY FOR PLANTS TO GROW FASTER AND FLOWER QUICKER

Replaces up to

600W

300W

The size of the lamp depends on the size of your growing goals. For a light user, we recommend a 2x2 tent best for growing 1-2 plants. Moderate production, generally a 3x3 tent will su�ce and you can grow 2-4 plants. For high production needs, use the monster 480W and you can grow up to 5-9 plants in a 4x4 grow tent.

120W

Replaces up to

250WReplaces up to Replaces up to

600W 1000W

120W 300W 480W1 - 2 plants 2 - 4 plants 4 + plants

PA-120

PA-300

PA-480

(MH) & (HPS) (MH) & (HPS) (MH) & (HPS)

Each LED module comes with various operating modes. On the backside, beside the electricity supply, are two toggle switches, it is possible to achieve di�erent operating-patterns and to save energy. The light spectrum of each PINEAPPLE LED product has been designed for the energy-e�cient cultivation of various plants and herbs. By using full spectrum LED chips and adding supplemental blue & red chips, we have replicated an amazing spectrum that your plants will love! Apart from that the LED module can be used for indoor hibernation, for professional operation and maximum light e�ciency, we recommend the deployment in a grow tent. For seedling stage,we recommend mounting 3 feet at least above the plant on VEG mode.

VEG Seedling or clone leads to Vegetative Stage –  Give 18-24 hours of light a dayThe vegetative state typically lasts Min 3-6 weeks Turn on the left button to trigger the veg spectrum

FLOWERIndoors most growers put their plants on a 12-12 schedule to initiate �owering. (12 hours on, 12 hours o�)Expect this stage to last about 6 weeks. Turn on both buttons to enhance to the full �ower/grow spectrum

Delivery Contents

Improper transportation may harm or can even cause damage to LED lamp housing box. In case of obvious damage or incomplete scope of supply, please refer to the support section of our website at www.pineappleled.com/support

Please handle and unbox the LED lamp with care! Check the delivery contents for completeness first.

1. Use the snap-hooks of the steel wires to connect the assembly eyelets

2. Hang the steel wires with the snap-hooks

3. Connect the power supply, then turn on the switch(s)

Growing conditions vary widely by location and crop. It is recommended that growers use a PAR meter to position the light so that it provides the correct amount of light for the plant. Generally, these grow lamps are mounted between 18 and 60 inches from the plants. When in doubt, start with the light further away from the plants and slowly move it closer as the plants adjust to the light.

What’s in the box:

Hanging Cables

Grow Light Fixture

Manual

Power Cord

Set-up

PINEAPPLE LED series Grow Lights are for indoor use only.

Do not expose to water drip or spray.

Do not expose the lights to physical harm such as impact or severe environmental conditions.

Working temperature is -4°F to 104°F.

Do not daisy chain the power connections on the PINEAPPLE LED series grow lights. Plug each light directly into power source. When installing PINEAPPLE LED series Grow Lights, ensure that the power outlets are properly grounded and have adequate capacity. If there is any doubt, please consult an electrician. Please ensure that there is adequate clearance for air�ow around the lights. A minimum of 12 inches of clearance are recommended above the light and 2 inches at the sides.

LED grow lights can cause eye damage. Avoid looking directly at the lights when they are on. Use shielding and light blocking glasses to protect your eyes.

Never place the lamp “face down” on a surface, as it may damage the lenses.

Recommendation: It is highly recommended that surge suppressors are installed to protect your grow light invest-ment. Power surges are one of the leading causes of prema-ture grow light failure.

For warranty information visit: pineapplepled.com/warranty

Note: PINEAPPLE LED grow lights are equipped with thermo-static fans. The fans will generally turn on a few minutes after the grow light is turned on. Fans may continue to run a few minutes after it is turned o�.

For more information please visit our website @ pineappleled.com

PINEAPPLE LED