quality description, a – planed · pitch pockets are allowed small missing knot is allowed ....
TRANSCRIPT
![Page 1: Quality Description, A – Planed · Pitch pockets are allowed Small missing knot is allowed . Small split of a knot on the edge is allowed. Small scars may appear. In general 8 cm](https://reader034.vdocument.in/reader034/viewer/2022051901/5ff06184a1ecad060144bbc3/html5/thumbnails/1.jpg)
Quality Description, A – Planed Quality: Lunawood® Thermo-D Raw Material: Pine (Pinus Sylvestris), Spruce (Picea Abies) Surface: Planed Installation: Decking Moisture: 6 % ± 2 % after production Tolerances: Width ± 0,50 mm Thickness ± 0,50 mm Length - 10 mm, + 30 mm
General Quality Evaluation • The influence of a single defect is evaluated by looking at the overall quality of the product. • Board is rejected if its overall look remarkably differs from the general quality requirements. • Several maximum defects in one product are allowed if the overall look remains acceptable. • In general 8 cm from the ends of the boars are not sorted. However end matched product are an exception.
![Page 2: Quality Description, A – Planed · Pitch pockets are allowed Small missing knot is allowed . Small split of a knot on the edge is allowed. Small scars may appear. In general 8 cm](https://reader034.vdocument.in/reader034/viewer/2022051901/5ff06184a1ecad060144bbc3/html5/thumbnails/2.jpg)
Small knothole (not throughout) on a board is allowed. Single crack of a knot is allowed.
Pitch pockets are allowed Small missing knot is allowed.
Small split of a knot on the edge is allowed. Small scars may appear.
In general 8 cm from the ends of the boars are not sorted. Small shakes on the surface are allowed.