RC & MRemote Control and Management SystemSystem of remote control and monitoring of telecommunication network sites

Purpose of RC&M

Remote control, management and monitoring of network equipment of RBS (radio base station), BSC (base station controller), MSC (mobile switch center) and other network sites of mobile network operators.

Purpose of RC&M

Complex provides data collection from different sources, that are used on a site (temperature/humidity sensors, electricity meters, alarm, fire and security sensors, power supplies system, diesel generators, network equipment etc.) and transfer this data to EMS.

Purpose of RC&M

Complex gives possibility of remote control from operator workplace to network equipment, power supply systems, diesel generator, climate systems, telecom equipment etc.

Complex provides organization of video security, alarm on entry to the territory of base station and access control to sites.

Main functi ons of the system

Control and monitoring of climate parameters: temperature and humidity

Control and monitoring of environment parameters: gas and dust pollution

Security and fire alarm, room flooding alarm

Creating ad-hoc report

Support different protocols of connection

Main functi ons of the system

Control, management and monitoring of power supply systems

Control, management and monitoring of diesel generators

Remote data collection of energy consumption on network sites

Automation of data processing for the calculation of consumed electricity

Main functi ons of the system

Remote troubleshooting of telecommunication site equipment for instance - BTS, DXX, XDM, MiniLink

Remote access from site to a corporate computer network

Outdoor and indoor video monitoring

Access control to the remote site and to individual rack units

Main functi ons of the system

System operability monitoring

Fault management (FM) and process tracking

SMS and E-mail messages

Administration and audit of users

Inventory management

Components of RC&M

PVS-LX

Controller PVS LX

EMS

Client software

Protocol software

System architecture of complex

Sensors and system equipment

PVS LX control ler

Computer: CPU ARM9 544 MHz; DRAM 128 MB; Flash 32 MB

Interfaces: 1x LAN, 1x WAN Ethernet 10/100 BaseT (RJ45);

5 Serial RS-232/RS485/С2; 2x USB 2.0; 1x 1-Wire;

16 x 3-level digital inputs; 2x outputs relay contacts

Temperature: -20℃～+55℃

Supply: 48V or 24V DC or 220V AC

Form factor: 1U rack

Hardware specifications:

READY / POWER

48V DC CLIMATE

COOLER / HEATER

LANPVS LX15

1 2 3 4 5WAN USB DIGITAl INPUTRS – 232/485

Control ler PVS-LX

OS: Linux Kernel Version: 2.6.27

Network protocols: TCP, UDP, IPv4, SNMP(v1,v2), ICMP, ARP,

SSH, DHCP, Telnet, FTP, PPP, DNS, HTTP, HTTPS, SMS, SMTP, SSL

Transfer protocols: RS232/RS485/С1, Modbus over TCP/ІР

Telecontrol protocol: IEC 60870-5-104

Electrical meter protocol: IEC 61107, IEC 1142,

IEC 61334 (DLMS/COSEM)

Security data: Secure Real COM, Secure TCP Server,

Secure TCP Client and Secure Pair Connection

Software specifications and protocols:

Components of RC&M

Alarm system

Electricity accounting system

Climate control system

Video security system

Access control system

Fault Management System

Components of RC&M

Control and management of network equipment

Administration of access permissions

Creating and editing forms of reports

Inventory management of resources

Control of power supply and diesel generator

RC&M Cl ient soft ware

User interface

Cl imate control system

• Measurement and monitoring of temperature and humidity• Charts and diagrams • Coolers/heaters autonomous/remote on/off• Formation of alarm messages in case of limits exceeding

Alarm system

• Signal discrete inputs monitoring of a fire and security alarm systems, backup power, etc.

• Alarm messages about event • Alarm audit system administration

CCTV system

• Twenty-four-hour simultaneous CCTV of many different points or areas on a single monitor with the ability to track movement in a frame

• Distributed video monitoring with the ability to view recordings at any time for analysis

• Video by motion detectors• Synchronic tracking of alarm signals

Electr ic ity accounti ng system

• Automatic data collection of technological and commercial electricity consumption accounting for each accounting point (group) equipment for defined commercial intervals

• Accumulation, processing and storage of accounting parameters • Comparative analysis of electricity consumption of similar sites• Control of electric power parameters (current, voltage, cos φ, frequency)

at a given polling interval

Consumed electr ic ity calculati on system

• Calculation of average consumption, taking into account losses• Providing multi-tariff zone accounting of electricity consumption (rates

are registered separately for each accounting point) • Maintenance of accounting contracts with electricity suppliers• Ad-hoc reports (daily, monthly, annual)• Control of electricity consumption limits• Electricity balance in the estimated group• Export data base on Oracle tool

Fault management system (FMS)

• Monitoring of connection to equipment • Creating of alarm messages • SMS and email notification • Easy adaptation to FMS based on SNMP protocols

Administrati on

• User profile • Access permissions• Audit

Ad-hoc reports

• Create and save of different type of reports• Automatic generation of reports based on system data• Print and export reports

Inventory management

• System equipment and connected devices • Oracle database • Audit of replacement equipment

Diagnosti cs of network equipment operati on

• Remote diagnostics of network equipment condition (switches, controllers, base radio stations, etc.)

• Adjustment parameter change

Management of power supply systems

• Remote control of parameters• Adjustment parameter change• Periodic remote testing of rechargeable batteries• Diagnostics of power supply system

Management of diesel generators

• Remote start/stop of generator• Remote load on/off• Control of voltage, current, frequency, battery voltage• Control of oil temperature, level and pressure • Control of fuel level, condition and running time

Air conditi oner remote control

• Control of environmental parameters • Remote control and diagnostic• Parameters setting• Analysis and diagnostic of cooling efficiency

Free cooling systems

• Setting parameters of operation• FreeCooler on/off• Control of temperature and engine speed• Own development

9 Franka str.Lviv79005Ukrainetel./fax : +38 032 235 8287www.mikrokod.com.ua

9 Franka str.Lviv79005Ukrainetel./fax : +38 032 235 8287www.mikrokod.com.ua