rev. : 02 (04t15)
TRANSCRIPT
Rev. : 02 (04T15)
Fuzzy
Fuzzy Wash (Normal Wash)
Wool Wash
Quick Wash
Silent Wash
Jeans Wash
Favorite Wash
Soak Wash
Eco Cotton
Tub CleanAir Dry
Delay Start (Reservation) Wash
Rev. : 02 (04T15)
ColdHot
Fuzzy (Normal) Wash
Jeans Wash
Eco Cotton
Wool Wash
Favorite Wash
Silent Wash
Quick Wash
Soak Wash
Tub Clean
Delay Start Wash
Option Wash
Favorite
Quick Wash
Soak
Delay Start
Spin, Rinse/Spin, Rinse, Wash/Rinse, Wash, Wash/Rinse/SpinSoak/Wash/Rinse/Spin
HotWarmCold
Water Temp
Cold Hot
Cold
Cold
Warm
Warm
Hot
Time Left, Delay Start(Reservation), Alarm Indication
Delay Start (Reservation) Button Program Button
Fuzzy WoolQuick Wash Jeans EcoCotton Silent Favorite
Tub Clean Fuzzy
Delay Start Indication (Reservation)
Delay Start (Reservation)(Res.=Delay)
Program
Wool
Quick Wash
Jeans
Eco Cotton
Water Detergent
Water Detergent
START / PAUSE
Water Level
Water Level
Hot/Cold
Water Level
Hot
Eco Cotton Warm Water level 4Wash 40 rinse 1 spin 9
Rev. :01 (03T15)
Soak Fuzzy Jeans Silent Favorite
ProgramSoak Wool Quick WashTub Clean
Wash SoakWash
SoakSoak
Wash
Water Level Water-Detergent
START / PAUSEWater Level
Favorite Favorite
Temp
WaterWater
Wash Rinse Spin
Favorite
Favorite
Favorite Program
Program Tub Clean
Water
Air Dry
Tub Dry
Wash Rinse
Wash Rinse
RinseSpin
Water
Rev. : 02 (04T15)
Program
Wool Tub Clean
Delay Start (Reservation)Delay
Time Left
Delay Start(Reservation)
Water Detergent Water
Delay Start (Reservation)
START / PAUSE
Rinse Spin
Rinse Spin
BeeperHigh HighLowOff
Beeper
Wash SpinRinse
High
Do not install the washer where it is directly exposed to sunlight, wind, rain etc.Plug the power cord of this washer into a properly installed standard power point that is switched & earthed.Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULLFLOW of any water that may leak out should the machine malfunction.It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area witha drain hole (or slope) that will prevent any possibility of water damage to floor coverings or property.Permissible water temperature : Max 70°C(160°F)Permissible water pressure : Max 80psi (550kpa, 8kg/cm2), Min 4psi (30kpa, 0.3kg/cm2)If water temperature & pressure is greater than above, it may cause damage to the machine. If youhave uncontrolled water temperature & pressure you should fit a temperature & pressure relief valveto ensure that water temperature & water pressure remains within the safe limits. Consult a plumberor electrician if you are unable to adjust water temperature and pressure.Do not over tighten the coupling nuts with a tool. Inlets are plastic : Do not strip or crossthread.
Rev. : 02 (04T15)
Cold Warm HotWarm
Hot/Cold
HotHot
Cold
Hot
Tub Clean Program
Memo
