scully water detector - national petroleum equipment · 2018-10-05 · scully systems europe nv...

1
ORDERING INFORMATION REPLACEMANT PARTS 00000 Rev A May 2014 Description Length Part Number WB 100 G 25' (7.6m) 08019 Description Part Number Sensor and Cable Assembly for the WB 100G 21326 9 Volt Replacement BAttery for the WB 100 G 26903 Water Detector DESCRIPTION The Scully WB 100G water detector is a battery operated, hand held unit. The unit is comprised of a rugged metal housing with audible alarm and a water detection sensor permanently attached via a two-conductor petroleum resistant cable. The weighted sensor is lowered into the fuel storage tank, boat bilge, truck compartment, etc. by simply unwinding the cable. The audible alarm will sound when the presence of water is detected. By lowering the weighted sensor to the bottom of the tank and raising it until the alarm shuts off, you can accurately measure the level of water within the tank. It’s as easy as using a drop line and less awkward and more accurate than a messy paste covered stick. The WB 100G water detector weighs less than four pounds. The unit is self-contained and easy to store. Consult Scully for special applications. FEATURES AND BENEFITS • Can be used in gasoline, gasohol, diesel fuel, jet fuels and #1 through #4 fuel oil. • Ideal for petroleum storage tanks, boat bilges and manholes. • Available in a variety of sizes for virtually all tanks. • No need for messy paste sticks. • Rugged, lightweight construction. • Inexpensive and easy to use. • Audible alarm indicates the presence and level of water. • Approval for use in hazardous areas. • Battery operated. TECHNICAL SPECIFICATIONS Sensor Material: Non-sparking brass Cable Jacket: PVC Sensor Diameter: 7/8" (2.2 cm) Housing Material: Zinc alloy, die cast Unit Height: 6" (15.2 cm) Power Requirements: 9 volt zinc-carbon battery Weight: 3 lbs. (1.4 kg.) Approvals: Factory Mutual Research and CSA for use in Class I, Division 1,Groups A, B, C & D Hazardous locations. Copyright © 2015 Scully Signal Company. Dynacheck, Dynamic Self-Checking, Dynamic Self-Testing, Faylsafe, Golden Gallon, IntelliCheck, Intellitrol, Mark IV, Sculclamp, Sculflow, Sculmatic, Twis-Lok, Unifil, Ventafil, Ventalarm, V.I.P. and Whistler are registered trademarksof Scully Signal Company. All Rights Reserved. Specifications are subject to change without notice. Scully Signal Company 70 Industrial Way Wilmington, MA 01887, USA 800 272 8559 • [email protected] Scully Systems Europe NV Maanstraat 25 2800 Mechelen, Belgium +32 (0) 15 56 00 70 • [email protected] Scully UK Ltd Meridian House, Unit 33 37 Road One Winsford Industrial Estate, Winsford Cheshire CW7 3QG, UK +44 (0) 1606 553805 • [email protected] Setting Standards in Safety and Dependability since 1936. Scully Water Detector The Portable Paste Problem Solver

Upload: others

Post on 17-Mar-2020

7 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: Scully Water Detector - National Petroleum Equipment · 2018-10-05 · Scully Systems Europe NV Maanstraat 25 2800 Mechelen, Belgium +32 (0) 15 56 00 70 • info@scully.be Scully

ORDERING INFORMATION

REPLACEMANT PARTS

00000 Rev AMay 2014

Description Length Part NumberWB 100 G 25' (7.6m) 08019

Description Part NumberSensor and Cable Assembly for the WB 100G 213269 Volt Replacement BAttery for the WB 100 G 26903

Water Detector

DESCRIPTIONThe Scully WB 100G water detector is a battery operated, hand held unit.The unit is comprised of a rugged metal housing with audible alarm and a water detection sensor permanently attached via a two-conductor petroleum resistant cable. The weighted sensor is lowered into the fuel storage tank, boat bilge, truck compartment, etc. by simply unwinding the cable. The audible alarm willsound when the presence of water is detected. By lowering the weighted sensor to the bottom of the tank and raising it until the alarm shuts off, you canaccurately measure the level of water within the tank. It’s as easy as using a drop line and less awkward and more accurate than a messy paste covered stick. The WB 100G water detector weighs less than four pounds. The unit is self-contained and easy to store. Consult Scully for special applications.

FEATURES AND BENEFITS• Can be used in gasoline, gasohol, diesel fuel,jet fuels and #1 through #4 fuel oil.• Ideal for petroleum storage tanks, boat bilgesand manholes.• Available in a variety of sizes for virtually all tanks.• No need for messy paste sticks.

• Rugged, lightweight construction.• Inexpensive and easy to use.• Audible alarm indicates the presenceand level of water.• Approval for use in hazardous areas.• Battery operated.

TECHNICAL SPECIFICATIONSSensor Material: Non-sparking brassCable Jacket: PVCSensor Diameter: 7/8" (2.2 cm)Housing Material: Zinc alloy, die castUnit Height: 6" (15.2 cm)

PowerRequirements: 9 volt zinc-carbon batteryWeight: 3 lbs. (1.4 kg.)Approvals: Factory Mutual Research and CSA for use in Class I, Division 1,Groups A, B, C & D Hazardous locations.

Copyright © 2015 Scully Signal Company. Dynacheck, Dynamic Self-Checking, Dynamic Self-Testing, Faylsafe, Golden Gallon, IntelliCheck, Intellitrol, Mark IV, Sculclamp, Scul�ow, Sculmatic, Twis-Lok, Uni�l, Venta�l, Ventalarm, V.I.P. and Whistler are registered trademarksof Scully Signal Company. All Rights Reserved. Speci�cations are subject to change without notice.

Scully Signal Company70 Industrial WayWilmington, MA 01887, USA800 272 8559 • [email protected]

Scully Systems Europe NVMaanstraat 252800 Mechelen, Belgium+32 (0) 15 56 00 70 • [email protected]

Scully UK LtdMeridian House, Unit 3337 Road One Winsford Industrial Estate,Winsford Cheshire CW7 3QG, UK+44 (0) 1606 553805 • [email protected]

Setting Standards in Safety and Dependability since 1936.

Scully Water DetectorThe Portable Paste Problem Solver