single loop analogue addressable fire control panel
TRANSCRIPT
Single Loop Analogue addressable fire control Panel
Single Loop Fire Control Panel
• 1 Loop not expandable Panel
• Up to 240 devices on the Loop
• LCD Graphic display
• Navigation keys
• System status leds
• 1 Extinguish channel optional card (certified according EN 12094-1)
• Certified according to EN54-4 ed EN54-2 by IMQ
• Low Cost
Single Loop Fire Control Panel
• New generation technology, software selectable protocol
• Up to 240 devices on the Loop
• Self addressing feature
• Up to 2000 m loop length
• Open Line or Loop selectable
• Loop diagnostic feature (detectors contamination level, Loop signal quality, real time value)
• Each device equiped with a short circuit Isolator
Single Loop Fire Control Panel
•1,4 A Switching Power supply
• Thermal compensated battery charger
• Battery supervision (efficiency check)
• 30 Zones
Single Loop Fire Control Panel
•Self restorable fuses protect outputs and battery
•Battery disconnection in case of deep discharge
•24V Output for external devices feed
•Supervised Dialer Output
• 1 A Supervised Alarm Output
• RS485 BUS for up to 4 repeater connection. On each repeater event view and scroll, reset silence etc.
• RS232 port for UP/Downloading
• 1 Supervised + 1 dry contact fault output
Single Loop Fire Control Panel
Using the LCD Graphic display the start up and all the requested programming can be easily done from the front panel
Single Loop Fire Control Panel
Using PC Software a clear indication of Loop devices which report the exact connection sequence is available
With a double click device’s parameters can be accessed
Single Loop Fire Control Panel
Real Time monitor of each device state is available where a wide range of information are reported
Single Loop Fire Control Panel
Up to 8 timers with yearly programming are available
Single Loop Fire Control Panel
Logic equation definable by installer to fulfill each installation requirement
Single Loop Fire Control Panel
•Optional Card for single channel extinguish system management
SMARTLetLoose/ONE
Single Loop Fire Control Panel
•CPD EN12094-1 Approved
Single Loop Fire Control Panel
• 1 supervised input for manual release• 1 supervised input for stop release
• 1 supervised input for pressure switch for baloon supervision and release confirm• 1 supervised output for Pre Extinguish signalling
• 1 supervised output for released signalling
Single Loop Fire Control Panel
•SmartLight/G : Up to 240 loop devices, 30 Zones
•SmartLight/S : up to 64 loop devices, 16 zones
•SmartLetLoose/ONE : single channel gas extinguish management card
THANK YOU