sports business sales cooperation · indoor flooring systems for multipurpose use ... as the...

Sports Business Sales Cooperation

Jürgen Widler


07.01.2013 CONICA Sports Surfaces 2

Status CEN 217, WG 2Indoor Flooring Systems for Multipurpose use

Harmonisation ofEN 14904



EN 14904Indoor Flooring Systems for Multipurpose use



Protection of Athletes

Reaction to Fire

Emission

Release of Dangerouse Substances

EN 14904Indoor Flooring Systems for Multipurpose useEssential requirements



Friction

Shock absorption

Protection of Athletes from Injury

EN 14904Indoor Flooring Systems for Multipurpose useEssential requirements for safety use



Reaction to Fire




Reaction to Fire

7

Small Burner Test: EN ISO 11925

Radiant Panel Test: EN ISO 9239-1



Radiant Panel Test


Reaction to Fire

8

European Classification: EN 13501-1

Small Burner Test

Smoke density

Critical heat flow



Reaction to Fire

Sports Flooring Systems

Mixed elastic

Area elastic Combined elastic

Point elastic



Reaction to Fire

Point elastic

The whole System has to be

tested and classified !For Area elastic and Combined elastic Systems with elastic construction:

- Top layer- load distribution plate - sleeper layer



Defined

Products

in defined

Systems



Emission ofDangerous substances



07.01.2013 13

Emission of Dangerous Substances

13



07.01.2013 14


14



07.01.2013 15


15



07.01.2013 16


16



17


17

The whole System has to be

tested and classified !



07.01.2013 1818

DefinedSystem

with

defined

Products


07.01.2013 1919


Emission of formaldehydeWhen formaldehyde-containing materials have been added to the product as a part of the production process, the product shall be tested and classified into one of two classes: E1 or E2NOTE Products of Class E1 can be used without causing an indoor air concentration greater than 0,1 x 10-6 mg/kg (0,1 ppm) of formaldehyde.The test requirement does not apply to sports floor systems to which no formaldehyde-containing materials were added during production or post-production processing. These need not be classified, but may, without any testing, be declared as Class E1.

Emission of pentachlorophenolSports floor systems shall not contain pentachlorophenol or a derivative thereof as a component in the production process of the product or of its raw materials. In cases where verification is required, if the content is less than 0,1 % by mass by the method described in Annex C, this requirement shall be considered to be met.




Friction





Test methods

Artificial Athlete Stuttgart

Triple A-Method




Type of test methodstill under discussion



Shock Absorption





PendulumEN 13036-4

Artificial Athlete BerlinDIN 18032-2

Test methods




Type of test methodstill under discussion



Construction Products

Directive (CPD)and CE-Marking

EN 14904Indoor Flooring Systems for Multipurpose use



Construction Products Directive (CPD)and CE-Marking & Labelling

CPDConstruction Products Directive

Construction Products Directive (CPD)

Art. 1 CPD(1) This Directive shall apply to construction products in so far as the essential requirements in respect of construction works under Article 3 (1) relate to them.

(2) For the purposes of this Directive, 'construction product' means any product which is produced for incorporation in a permanent manner in constructionworks, including both buildings and civil engineering works




CPDConstruction Products Directive

Construction Products Directive (CPD)ESSENTIAL REQUIREMENTS

The products must be suitable for construction works which“satisfy the following essential requirements “1. Mechanical resistance and stability2. Safety in case of fire3. Hygiene, health and the environment4. Safety in use5. Protection against noise6. Energy economy and heat retention




CE-Marking &

Labelling




Scope and relevant clausesThis European Standard has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association.The clauses shown in this annex meet the requirements of the mandate given under the EU Construction Products Directive (89/106).Compliance with these clauses confers a presumption of fitness of the construction product covered by this European Standard for its intended use(s) under the mandate; reference shall be made to the information accompanying the CE marking.

CE-LabellingEN 14904

CE-Labelling – EN 14904


Sports Products:The safety that all the "Sports" products for gymnasiums, ranging from theproduction of the product to the processing on site correspond with the datadefined in the initial testing.

Background

General: The CE-label is a label under EU law for certain products in relation to productsafety. By affixing the CE marking, the manufacturer confirms that the productcomplies with current European directives. The CE marking is a kind of passportfor the European market.



07.01.2013 CONICA Sports Surfaces



Systems of attestation ofconformity

System 1Flame retardants in the System


System 3No flame retardants in the System

Sports Business Sales CooperationConstruction Products Directive (CPD)

and CE-Marking & Labelling

Initial Test




CE-Declaration





Tested parameters shown in the Technical Bulletin





CE-Label

Year of identification: 2007

Reference to EN 14 904-

normalization








Additionally, annual monitoring from a notified body

Analogous to System 3

Sports Business Sales CooperationConstruction Products Directive (CPD)

and CE-Marking & Labelling


CE-Certificate from a notified body

Sports Business Sales CooperationTHANK YOU

CONICA - Your professional partner!

sports business sales cooperation · indoor flooring systems for multipurpose use ... as the...

Documents