technical details | ergoldsbacher e58 flat pantile and e58...
TRANSCRIPT
Ergoldsbacher E58 flat pantile also
available in the large E58 MAX® format.
Germany’s favourite clay pantile, the
Ergoldsbacher E58 flat pantile, and the
E58 MAX® are particularly resistant to rain thanks to their
interlocking head and feet as well as genuine inter locking
double sides. Their large interlocking tolerance makes
them considerably easier to lay. The Ergoldsbacher E58
MAX® offers the advantage of 20% greater coverage.
A bestseller | Ergoldsbacher E58 flat pantile / E58 MAX®
Additional measures required when laying Ergoldsbacher E58 flat pantiles and E58 MAX® in accordance with basic DDH regulations, recommended roof pitch: 20°, minimum roof pitch: 10°.
Increased requirements
Roof pitch in degrees
(rafter pitch)
≥ 20o Roofing membrane Roofing membrane Overlapping or interlocking underlay
≥ 14o Roofing membrane Roofing membrane Overlapping underlay Welded or glued underlay
≥ 10o Rainproof roofing membrane
Rainproof roofing membrane
Rainproof roofing membrane
Waterproof roofing membrane
No additional increased requirements
One additional increased requirement
Two additional increased requirements
Three additional increased requirements
Useof the attic storey,
particularly for residential purposes
Construction * Special roof designs(e.g. butterfly roofs)
* Long rafters * Complex roof structures
(e.g. with dormers, roof channels etc.)
Climatic conditions * Exposed location
* Extreme sites* Areas with heavy snow
* Windy areas* Particular weather conditions
The additional measures described in the table are minimum requirements. Where the requirements are particularly high and/or there are specific, difficult conditions on site, a more effective additional measure must be used (see data sheet for roofing membra-nes, table 1, DDH regulations). More effective additional measures can always be used instead of the minimum measures.
Over a billion sold.
Like all Ergoldsbacher clay roof tiles, the Ergoldsbacher flat pantile E58 and the E58 MAX® tiles exceed the quality requirements set out in the DIN EN 1304 roof-tile norm. Ergoldsbacher roof tiles are natural building materials through and through. This is also evident from the fact that the individual tiles display slight variations in colour.Given that the regulations and roofing traditions vary throughout Europe, our manufacturer’s instructions should be given priority when you lay the tiles.The sizes and weights given are nomi-nal values. Owing to changes in the raw materials and varying shrinkage characteristics, it is not always possible to prevent deviations. It is therefore advisable to check the dimensions of the roof before laying the tiles.Occasional imperfections are an inherent part of the production/trans-portation process and do not affect the quality of the roof tiles.This brochure was last updated in June 2008. We reserve the right to make changes to the models and colours available.
2.75 tiles per m 2.66 tiles per m 2.6 tiles per m
Ridge tile No. 19
Ridge link sliding tile verge left
Ridge link sliding tile
Ridge tile No. 15 Standard hip capRidge tile No. 18
The following non-ceramic accessories are also available:
Metal E 58 pantile · Ridge and ridge lath holders · Aluminium clamps for ridge and hip tiles · Starter and end plates · Skylights with glass (copper or colour-coated red/grey, 42/52 cm) · Erlus roof walkway system (colour-coated aluminium) · Erlus aluminium snow guard system · Erlus aluminium sanitary ventilator (125 mm) · Plastic thermal adapters · Erlus aluminium antenna outletThese are just a few of the accessories available. Please request our accessories brochure!
Colours: The Ergoldsbacher E58 flat pantile is available in natural red, red engobed, copper brown engobed, Brazil brown engobed, e’cotta engobed, anthracite engobed, rustic engobed, special maroon engobe, special root timber engobe, special diamond black engobe and special cobalt blue engobe as well as in Lotus red, Lotus brown and Lotus black.
The Ergoldsbacher E58 MAX® is available in natural red, red engobed, copper brown engobed, anthracite engo-bed, special maroon engobe, special diamond black engobe, special cobalt blue engobe, special titanium silver engobe and special royal green engobe as well as in Lotus red, Lotus brown and Lotus black.
Now available in ERLUS LOTUS too. Request our separate brochure for the first ever self-cleaning clay roof.
E 58 E 58 MAX® Size in cm: approx. 26.0 x 42.0 approx. 29.0 x 46.5 Cover length range: Ø 34.0 cm Ø 38.5 cm approx. 33.8-34.3 cm approx. 38.1-38.8 cmAverage cover width: approx. 20.2 cm approx. 22.7 cmQuantity required per m2: approx. 14.5 tiles approx. 11.5 tilesWeight per tile: approx. 3.1 kg approx. 3.7 kgWeight per m2 incl. battens in accordance with DIN 1055: approx. 0.55 kN/m2 approx. 0.55 kN/m2
Real weight: approx. 45 kg/m2 approx. 42.5 kg/m2
Technical data:
Ø 15.5 cm2 (Ø 22 cm2)(No. of tiles/m2 depends on roof pitch and snow load)
Ø 125 mm ventilation shaft =122 cm2
Recommended for roof ventilation with rafters up to 10 m in length, can be dry-laid up to 45°.
For all ridge tiles
Ridge link sliding tileverge right
Ridge link ventilation sliding tile
Ridge link tileverge left
Ridge link tile Ridge link tileverge right
Ridge link double roll tile
Verge tile left Standard tile Verge tile right Double roll tile
Pent roof verge tile left Pent roof tile Pent roof verge tile right Pent roof double roll tile
Snow guard tile Ventilation tile Aluminium solar outlet tile Aluminium sanitary ventilator
Ø 9 cm2 (Ø 12 cm2)
Ridge tile No. 21
The dimensions indicated are planning values and should be checked before tiles are laid.
X = distance from ridge vertex.
(approx. 39.7 cm)
(approx. 38.5 cm)
approx. 35.3 cm
approx. 34.0 cm Roof pitch
* = Lath 24/48 nessesary
(30) (30) (25) (25) (25) (20) (15)
35353030302520
18o
20o
25o
30o
35o
40o
45o *
(80) (75) (70) (65) (60) (55) (45)
80 75 70 65 60 55 45
Attachm. to 1st lath from ridge vertex
(approx. mm)
Overall height incl. stand. lath 30 x 50 mm from
ridge vertex (approx. mm)
The dimensions indicated are planning values and should be checked before tiles are laid. X = distance from ridge vertex.
Slide on up to 15 cm LW after removal of rear support notch
Roof pitch18o
20o
25o
30o
35o
40o
45o
50o
(45) (43) (40) (40) (40) (35) (35)(30)
5048454545404035
Ridge tile F 15(mm)
(approx. 17.5 cm)
approx. 3.2 cm
(approx. 22.7 cm) (approx. 22.7 cm)
approx. 17.0 cm approx. 20.2 cm approx. 20.2 cmPlumb line every 5 rows of tiles
Left verge
approx. 20.2 cm approx. 20.2 cm approx. 19.0 cmPlumb line every 5 rows of tiles
Right verge
(approx. 38.5 cm)
approx. 31.0 cm
(approx. 36.0 cm)
(approx. 44.0 cm)
approx. 34.0 cm
approx. 39.0 cm
intake air
Eaves with insulation over rafters
(approx. 38.5 cm)
(approx. 44.0 cm)
approx. 34.0 cm
approx. 39.0 cm
taken in approx. 3 cm
hand-crafted perforated plate strip
intake air
Eaves with drainage subroof
approx. 34.0 cm
approx. 34.0 cm
approx. 24.6 cm
approx.
4.0 cm
(approx. 38.5 cm)
(approx. 38.5 cm)
(approx. 28.8 cm)
Ventilation in accor-dance with DIN and other pro-fessional regulations
Pent roof end
approx. 34.0 cm
(approx. 38.5 cm)
approx. 34.0 cm
(approx. 38.5 cm)
Erlus roof walkway system
approx. 3.2 cm
The CAD drawings are produced to scale. The scale shown here is 1:10 for the E58 Flat Pantile. (E58 MAX® x 1.14) Using a photocopier, enlarge the drawings by 200% (218% for the E58 MAX®) to obtain a scale of 1:5.All drawings are also available on the Internet at www.erlus.com
The dimensions for E 58 MAX® are indicated in parenthesis and bold
made of rustproof steel/aluminiumtested in accordance with DIN EN 516
- no support laths required -Step grate 46 cm or 80 cm
- also available as extension grate -
Step
Aluminium tile screwed to lathing twice(V2A screws included)
Roof lath 30 x 50 mmAttached to counter-lathing in two places
Dry-laid ridge No. 15 with sliding ridge link ventilation tiles
approx. 7.5 cm
(approx. 22.7 cm) (approx. 22.7 cm) (approx. 20.5 cm)
Dry-laid ridge with ridge ventilation tile No. 19
X
The screw hole in the verge on flat roofs should be permanently sealed (e.g. using plumbing screws)
The screw hole in the verge on flat roofs should be permanently sealed (e.g. using plumbing screws)
X after removal of rear
support notch15.0-33.0 cm LW
(15.0-37.5 cm LW) approx. 34.0 cm
(approx. 38.5 cm)
main weather side
fastened with sheathed Erlus V2A stainless steel
ridge clamp
Article ≤ 45° > 45°
Step areas
(grates 46 cm)
E58 every other tile
row E58MAX
every row
E58 and E58MAX every tile
row
Individ. step
(step)
E58 u. E58MAX every tile
row
E58 and E58MAX every tile
row
Laying according to DIN 18160-5
approx. 7.5 cm
Rustic engobed (E58 flat pantile only)
Special titanium silver engobe (E58 MAX® only)Special maroon engobe
Natural red / Lotus red
Anthracite engobed / Lotus blackSpecial royal green engobe (E58 MAX® only)
Red engobed
Special root timber engobe (E58 flat pantile only)
Special diamond black engobe
Brazil brown engobed (E58 flat pantile only)
Special cobalt blue engobe
Copper brown engobed / Lotus brown
e’cotta (E58 flat pantile only)
Not only the design, but also the colours of Erlus ceramic roof tiles are "exclusive". They harmonise with the colours of surrounding roofs.
(Only the colour of the original roof tiles is gua-ranteed)
0808
/0/T
Y/pi
pr/E
58uM
-eng
l./1.
2
Special root timber engobe (E58 flat pantile only)
Copper brown engobed / Lotus brown
Handed over by:
Erlus AG Main office Hauptstraße 106 · D-84088 Neufahrn/NB Tel: +49 (0)8773 18-0 · Fax: +49 (0)8773 18-300 E-Mail: [email protected] Website: www.erlus.com
Erlus Logistics Centre Herrenteich 68766 Hockenheim-Herrenteich Tel: +49 (0)6205 2095-0 · Fax: +49 (0)8773 18-113
GIMA factory Marklkofen Girnghuber GmbH Ludwig-Girnghuber Str. 1 · D-84163 Marklkofen Tel: +49 (0)8732 24-0 · Fax: +49 (0)8732 24-200 E-Mail: [email protected] Website: www.gima-ziegel.de
Erlus Logistics Centre Bassum Wilh. Detmers-Janssen, haulage Graf-Zeppelin-Ring 19 · 27211 Bassum Tel: +49 (0)4241 9393-0 · Telefax: 04241 5050
Erlus Logistics Centre Brüggen Stiegstraße 60 · 41379 Brüggen Tel: +49 (0)2157 1419-13 · Fax: +49 (0)2157 1419-17
Erlus Logistics Centre Ronneburg Brunnenstraße 82 · 07580 Ronneburg Tel: +49 (0)36602 399-18 · Fax: +49 (0)36602 399-75
Erlus Logistics Centre Steinheim Hermann Enderle, forwarding company Talstraße 2 · 71711 Steinheim-Höpfigheim Tel: +49 (0)7144 21467 · Fax: +49 (0)7144 23066
Erlus AGErgoldsbach factory Industriestraße 7 · D-84061 Ergoldsbach Sales office / Service desk for chimney systems Tel: +49 (0)8773 18-450, 18-451 Fax: +49 (0)8773 18-455, 18-140
Bernhard tile factory Erlus factory Teistungen Hundeshagener Str. 3 · 37339 Teistungen Tel: +49 (0)36071 826-23 · Fax: +49 (0)36071 826-22
The following brochure is a translation from the German language . Since differences may occur due to language-based interpretation, we explicitly indicate that only the original German content is binding. When in doubt, the DIN EN 1304 regulation shall always apply.
Copyright notice© ERLUS AG 2008. All rights reserved. These documents are protected by copyright. They may not be reproduced, modified, distributed in any form or way or saved in a database or other data storage system – either in full or in part – without the prior consent of ERLUS AG.Any use of these documents without prior consent shall count as a breach of the relevant copyright regulations.