8/17/2019 Trace Diagnostics for Masterdrive VC Using Drive Monitor - Siemens Industry Online Support - Technical Forum (Gu…

1/3

Page 1 of 1 (3 items )

Top

Print documentTechnical Forum

SIMOVERT MASTERDRIVES

Trace diagnostics for Masterdrive VC using Drive Monitor 

Thread Starter: Goran_   Started: 3/2/2010 5:47 PM  Replies: 2

« Previous thread Next thread »

  3/2/2010, 5:47 PM

Goran_ 

Joined 3/24/2008

Last visit: 10/20/2011

Posts: 103

Rating:

 (0)

(0)

I would like to monitor values of speed, current, voltage, torque, encoder 

feedback, etc using trace diagnostics function in Drive Monitor. Since there is

no good manual about using Trace function, I need to clear some things

about it.

I need to set recording interval - what would be the bes t value for it? Since I

am monitoring encoder feedback, then this value should be equal to

sampling time, or?

Pretrigger range - this can be from no pretrigger to maximum prtrigger. What

exactly does it mean, and when do I need pretrigger, and when I dont need

it?

Trigger channel - I guess this should be a speed setpoint connector > 0 in

my example?

 After I make adequate settings, I click on Start, then run the motor, and after 

som e time, I click on Stop, and then click on Read Data. Is this all that it is

needed, or there are some other important notes?

http://www.automation.siemens.com/WW/forum/guests/UserProfile.aspx?UserID=21628&Language=enhttp://www.automation.siemens.com/WW/forum/guests/PostShow.aspx?PageIndex=1&PostID=197676&Language=en#tophttp://www.automation.siemens.com/WW/forum/guests/PostShow.aspx?PageIndex=1&PostID=198045&Language=en#tophttp://www.automation.siemens.com/WW/forum/guests/PostShow.aspx?PostID=197950&language=en#http://www.automation.siemens.com/WW/forum/guests/PostShow.aspx?PostID=197950&language=en#

8/17/2019 Trace Diagnostics for Masterdrive VC Using Drive Monitor - Siemens Industry Online Support - Technical Forum (Gu…

2/3

8/17/2019 Trace Diagnostics for Masterdrive VC Using Drive Monitor - Siemens Industry Online Support - Technical Forum (Gu…

3/3

Top

Page 1 of 1 (3 items )

  3/5/2010, 7:27 AM

Goran_ 

Joined 3/24/2008

Last visit: 10/20/2011

Posts: 103

Rating:

 (0)

(0)

THank you for the prompt and clear explanation.

Actions

Copy Link

To conference

© Siemens AG 2013 - Corporate Information - Privacy Pol icy - Terms of Use

http://www.siemens.com/terms_of_usehttp://www.siemens.com/privacyhttp://www.siemens.com/corporate_infohttp://www.automation.siemens.com/WW/forum/guests/Conference.aspx?SortField=LastPostDate&SortOrder=Descending&ForumID=154&Language=enhttp://www.automation.siemens.com/WW/forum/guests/UserProfile.aspx?UserID=21628&Language=enhttp://www.automation.siemens.com/WW/forum/guests/PostShow.aspx?PostID=197950&language=en#