For further technical information please call 01932 732 331 or use our fax back service on 01932 732338.Contact us via E-mail kevin.south@vestatec.co.uk or craig.budge@vestatec.co.uk.

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS

NOTE: The information supplied by the technical help desk is purely indicative and should be tested with a digital volt meter prior to connection. Vestatec (UK) Ltd will not accept liability for anydamage caused to a vehicle through incorrect installation. This document may not be reproduced or exhibited to a third party without prior written permission from Vestatec (UK) Ltd

DOC.Craig Budge.sprinter 96.12.01

1) Dissarm allarm with existing working radio/touch key

2) Turn ignition on

3) Touch existing touch key onto the recepticle

4) Press and hold both buttons on remote untill LED stops flashing (about ten seconds)

5) Press large button twice

6) Repeate step 4. and 5. for all raidio keys needed to work on system max 4 keys (system deletes its memory of all keys previously working on system so old keys will need to be programed in)

7) To exit programing turn off ignition

NOTE :-

If a touch key is needed to be programed into the system you will needa cobra jolly programmer

contact the technical help desk for more information

6422 RADIO KEY PROGRAMING