celtic bar bracelet - paracordgalaxy.com
TRANSCRIPT
Website: paracordgalaxy.com Email: [email protected] Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our
website.
Materials:
{Cost for this project starts at $2.99}
https://paracordgalaxy.com/
World's Largest Selection Of USA made 550 Paracord In 1,000 + Colors and
Patterns
Celtic Bar Bracelet
Four 6 foot pieces of Type 1 paracord or larger
Step 1: Find the center of all four cords. Lay two cords vertically (A) and two
horizontally (B) at the centers.
Step 2: Bring the top half of cords A down and to the right below your horizontal
cords.
Step 3: Bring the right side of color B down over color A.
Step 4: Take the left side of color B behind color A.
Website: paracordgalaxy.com Email: [email protected] Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our
website.
World's Largest Selection Of USA made 550 Paracord In 1,000 + Colors and
Patterns
Step 5: Cross the left side of color B over the right side of color B and pull tight.
Leave a loop in color A about a half inch. You may find it helpful to secure loop A as
you work.
Step 6: Take the right side of color A and lay it over the right side of color B.
Step 7: Take the left side of color A and bring it behind the left side of color B.
Step 8: Cross the left side of color A over the right side of color A.
Pull cords tight, but keep your braiding flat. Repeat steps 6 through 8 with color B.
Repeat the same process always working with the color on the top until you reach
the desired length
Website: paracordgalaxy.com Email: [email protected] Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our
website.
World's Largest Selection Of USA made 550 Paracord In 1,000 + Colors and
Patterns
Separate the cords as shown using the top-most cord on the right and left as cord
1 and 2.
Step 9: Bring cord 1 over all the center cords and under cord 2.
Step 10: Take cord 2 under all the center cords and up through the loop created by
cord 1. Pull the knot tight.
Repeat steps 9 and 10 to create a square knot. Pull tight and trim and melt the ends
of cords 1 and 2.
Using the remaining six strands to tie a diamond knot using three strands as if they were one. See our diamond knot
tutorial for detailed instructions.
Trim and melt all remaining strands. We used Type 1 paracord for this bracelet and
the end product was about ½ inch wide.