Specs: F-15 Park Jet3D Foamy

Loading

Area

Radio

Weight

4-5 Chanel

Thrust

Copyright © 2004 3DFoa All rights reserved.Designed and Drawn by:Steve Shumate & Levi JoUpdated: 0/19/2004

14-24 oz.

14-18 oz.

289.7 in2

6.5-8.6 oz/ft2

WWW.3DFOAMY.COM

Jet 3DFoamy.com.

rved.wn by: Levi Jordan04

Cut a "V" groovein foam forspars. Pull sparthrough grooveto make round

Start with the recomendedCG range. You can adjust itfurther back as you become

more familiar with the jet.

CG INFO

All hingingtape or acpoints epoand contro

nging for control surfaces can be packingor actual hinges. I prefer robart hinges epoxied in place for the added longivityontrol freeness. CA hinges work well also.

Sand the fuselage corners roundwith 80 grit sand paper,

then finish smooth with 200 and 400

Depron Rails

4

5

6

Prototype Setup/SpecsWing area: 289 sq in (effective area, which includSpan: 28.4 inLength: 41.7 inWeight RTF: 15.6 oz as shownWing loading: 8.2 oz/ft2 (based on effective wingMotor: GWS EPS-350 with “C” gearingBattery: 11.1V 1200 mAh LipoProp: GWS 8x6 SFCurrent draw: 9.7 ampsPower loading: 101 watts/lbRadio equipment: GWS R-6 receiver, GWS Pico aFlight controls: Wing flaperons, full-flying horizoMaterials used: Either 6mm Depron or BlueCore

sncludes the effect of the wing strakes)

wing area)

ico and Hitec HS-55 servos, 10 amp ESCorizontal stabilizer, twin ruddersCore fan fold foam

Pull PullPush/Pull

Cut Control horns from 1/32"

ply or a plastic coffee can lid.

Round LE, apply 3M 1" Satin tape for protection

1 2 3 4 5 6

1

2

3

Flight controls: Wing flaperons, full-flying horizoMaterials used: Either 6mm Depron or BlueCore

Foam Nose Cone

(CNC Cut, Sanded to shape)

orizontal stabilizer, twin ruddersCore fan fold foam

Vacu

(San

Vacuum Formed Canopy

(Sand from foam if scratch built)

www.3DFoam

Cut hatch after painting

for radio access

amy.com

Laser cut 1/4" birch motor block.

Epoxy into plane. DO NOT use CA on the moutor mount.

HS

-56

HB

k.

e t.