HANDLE JOG MODE

The HAAS ControlSeries

PRESS

THREE TIMES TO GET TOTHIS PAGE

(Continued onnext slide)

Note:

SLIDE LEGEND

ACTIONS

INSTRUCTIONS

KEYS

INFORMATION

To advance through the presentation

click on your left mouse button

or press <ENTER>.

To exit press <ESC>.

To advance through the presentation

click on your left mouse button

or press <ENTER>.

To exit press <ESC>. OTHER INFORMATION

HANDLE JOG MODEThis module is

intended to provide you with a

familiarizationof the Handle Jog Mode on the Haas

Control

Here is where you find the Handle Jog Buttons

Pressing the Handle Jog button on the control will display the Position screen. Used to manually move the machine axes by using the Jog Keys or the Hand Wheel.

Handle Jog Buttons

HANDLE JOG:

.0001 .1:

.001 1.:

.01 10.:

.1 100.:

Handle Jog Button:

Handle Jog Button:

Press<HANDLE JOG>

This will bring up the Position screen that will allow you to move the machine axes by using

the Jog keys or the Hand wheel.

If you select the DIST-TO-GO display, it will

zero all axes when you select the Handle Jog

Mode of operation.

POSITION (EDIT) O91002 F1 KEY TURNS MENU ON/OFF

(OPERATOR) (WORK G54)

X 0.0000 in X 12.1705 in

Y 0.0000 in Y 8.0000 in

Z 0.0000 in Z 0.0000 in

(MACHINE) (DIST TO GO)

X 0.0000 in X 12.1705 in

Y 0.0000 in Y 8.0000 in

Z 0.0000 in Z 0.0000 in

JOGGING AXIS @ FEED 1.

Resolution/Feed Rate Buttons:

These four keys select Hand wheel Resolution and the Jog Feed Rate.

The number on the top indicates Hand wheel

Resolution.(Amount of movement

per click)

The number on the bottom indicates the

Jog Feed Rate in inches per minute when using

the Jog keys.

An axis must be selected for movement

to occur.

POSITION (EDIT) O91002 F1 KEY TURNS MENU ON/OFF

(OPERATOR) (WORK G54)

X 0.0000 in X 12.1705 in

Y 0.0000 in Y 8.0000 in

Z 0.0000 in Z 0.0000 in

(MACHINE) (DIST TO GO)

X 0.0000 in X 12.1705 in

Y 0.0000 in Y 8.0000 in

Z 0.0000 in Z 0.0000 in

JOGGING AXIS @ FEED 1.

Handle Jog:While jogging the machine, the FEED RATE OVERRIDE buttons will adjust, in increments of +/-10%, the feed rate that is programmed into the control.

The Hand Wheel can be used to adjust, in increments of 1%, the feed rate that is programmed into the control.

Handle Jog:With the spindle running, the SPINDLE OVERRIDE buttons will adjust, in increments of +/-10%, the speed that is programmed into the control.

The Hand Wheel can be used to adjust, in increments of 1%, the speed that is programmed into the control.

Handle Jog:

The JOG LOCK key will cause the axes you are jogging to continue jogging. Press <JOG LOCK> then press the axis key you want to jog.

While in motion, you can switch axis by pressing the axis you want to move.

Motion will stop by pressing <JOG LOCK>, <FEED HOLD> or <RESET>.

Prepared by Haas AutomationTraining DepartmentOxnard, CA 93030