new spit pulsa 800e cordless gas nailer for electrical ... · new spit pulsa 800e cordless gas...
TRANSCRIPT
80 www.itwcp.co.ukTechnical Helpline UK: 0800 731 4924Technical Helpline ROI: 1 800 882 388
Spi
t:D
irec
t Fi
s
NEW Spit Pulsa 800E Cordless Gas Nailer For Electrical Cable and Conduit Management
Noise / Vibration Information Noise Emissions: Measured values determined according to EN 12549.
LwA, 1s dB (A) 108LpA, 1s dB (A) 101
HAV: The typical weighted accelerationdoes not exceed 4.5m/s2.
The NEW Pulsa 800E cordless gas nailer is a secure and fast solution for fixing electrical cable management to steel and concrete.
Eurocode & Description
Eurocode: 018350 Box QtyPulsa 800E (20 pin magazine) 1
Technical Specification
Weight: 3.8kg
Dimensions: 385 x 114 x 309mm(Lxlxh)
MagazineCapacity: 20 pins
Impact Force: 82J
ActuationPressure: 4.5kg
Intermittent operation: 2 pins per second
Fuel Cell Life: 750 shots
Includes:Spit Pulsa 800E Cordless Gas Nailer, high impact carry case, single shot cover guard, 1 x LITHIUM battery, battery charger, safety glasses with EN166:F, allen key and instruction manual
NEW
Drives 100% more pins per charge; up to 3,000 shots; could result in only charging a battery every 2 weeks.
Technology: LITHIUM
Voltage: 3.7V
Capacity: 2.2Ah
Shots Per 1,500 min /Charge: up to 3,000
Charge Time: 90 mins (25 mins = 500 pins)
Fuel Injection System
Powered by an intelligent electronic fuel injection system. The fuel injection valve delivers the exact dosage of fuel required for your current working temperature, giving you the nailing performance you need between -15ºC and +49ºC.
Battery Specification
Features and Advantages
• Start & Go technology - Tool sleeps after one minute of inactivity. Instant START and ready to GO activated with any motion. No battery discharge when not in use
• Intelligent Fuel Injection - Slide in fuel locks in place and ejects easily
• Steel O Ring - Only 4.5kg of push down actuation force needed.
• Exhaust Fan - The best cooling system of any tool
• Dust Protection - Crucial for overhead applications and dusty environments.
• Easy Servicing - Twist and clean rear cap and filter
Single Shot Blanking Plate - tailor made to allow the tool to handle single shot pins (soft washered) safely.
Eurocode: 018490
SINGLE SHOT BLANKING PLATE AVAILABLE
–15 °C
+49 °C
FuelInjectionSystem
PULS
A 8
00
LITHIUM-ION
81www.itwcp.ie
Gas Systems
Spi
t:D
irec
t Fi
s
CLIP ELEC CONDUITCLIP
CT-CLIP E-CAV P-CLIP CABLE BOW
STEEL BAND
METAL CLIPS
TRH CLIP*
HC615-17
HC615-17
HC615-17
HC615-17
HC615
HC617-22
HC622
HC617-22
HC622
HC617-22
HC622-27
HC627 - 32
HC622-32
HC627-32
HC622-32
C625-30
C630 - 35
C625-30
C630-35
C620-25
25
HC6C6 SELECTION
STEELHARD CONCRETECONCRETE& BRICK
FIREFIX™
*M6 - M8 Threaded Rod maximum length 600mm, static loads only, install at right angles.
Call the Technical Helpline on 0800 731 4924.
Steel:min. thickness = 6.5mmrecommended static load = 150kg Concrete:recommended static load = 10kg
TIP
NEW Spit Pulsa 800E Cordless Gas Nailer For Electrical Cable and Conduit Management
Applications
Cable and Conduit Management• Skirting and dado trunking systems• Mini trunking systems••Metal trunking systems• Low voltage cabling and temporary lighting• Metal and plastic capping • Fire resistant cabling systems (Prysmian Firefix™)
Wiring Accessories• Metal back boxes• PVC - U back boxes••PVC - U conduit••Steel conduit• Junction boxes••Switch boxes••Smoke detectors
Substrates
• Concrete• Steel• Solid block and brick• Pre-cast hollow pot• Pre-stressed concrete• Reinforced concrete
Accessories
Please refer to page 85.
800E Pin Selection Guide
All Pulsa 800E/700E Cableand Conduit ManagementAccessories are compatible with the Pulsa 800E/700E Refer to pages 82 - 84.
C6 Pins - Standard Concrete (C25)
PULSA 800 CONSUMABLES ONLY
HC6 Pins - Hard Concrete (>C25) and Steel
HC6 Pins, Flush Head - Hard Concrete (>C25) and Steel
For use in harder substrates with higher aggregate content. Collation stays intact when fixed.
Collation fragments on impact to leave pin ‘flush’ to the fixed article.
Eurocode Description Length Collation Box Qty
057540 C6 20 20mm Black 500 057541 C6 25 25mm Black 500057542 C6 30 30mm Black 500 057543 C6 35 35mm Black 500057544 C6 40 FH 40mm White 500 10 strip collation (suitable for 20 and 50 pin magazine) + 1 x Fuel Cell
Eurocode Description Length Collation Box Qty
057550 HC6 15 15mm Orange 500 057551 HC6 17 17mm Orange 500057552 HC6 22 22mm Orange 500 057553 HC6 27 27mm Orange 500057554 HC6 32 32mm Orange 50010 strip collation (suitable for 20 and 50 pin magazine) + 1 x Fuel Cell
Eurocode Description Length Collation Box Qty
057555 HC6 15 FH 15mm White 500 057556 HC6 17 FH 17mm White 500057557 HC6 22 FH 22mm White 500 057558 HC6 27 FH 27mm White 50010 strip collation (suitable for 20 and 50 pin magazine) + 1 x Fuel Cell
Eurocode Description Length Collation Box Qty
057567 HCG6 15 (steel only) 15mm White 500 057568 HCG6 22 (steel only) 22mm White 500057563 CG6 20 20mm White 500 057564 CG6 25 25mm White 500057565 CG6 30 30mm White 500057566 CG6 35 35mm White 50010 strip collation + 1 x Fuel Cell. Single shot only - cannot be used in magazine.
CG6 Pins Soft Washered - Standard Concrete (C25)
SINGLE SHOT ONLY
For fixing brittle articles. The collation cushions the head of the pin to reduce impact.
For use in standard applications. Collation stays intact when fixed.