schams solar flyer mppt-en
DESCRIPTION
Products that will improve 30% output of the solar panels and wind generatorsTRANSCRIPT
Our CompanyThe know-how of Schams-Electronic Ltd. is •based on more than 15 years of experience in the development of MPP Solar Charge Con-trollers and is state-of-the-art.
Our controllers are used worldwide, even in •the Antarctic.
Development with modern simulation pro-•grammes.
MPP-Charge ControllerWould you like to guarantee your customers an op-timum of solar power, not only during sunshine, but also during periods of bad weather, in winter and in summer while the accu is not overloaded and the wiring does not require great skills? In this case, you willfindourcontrollersverysuitable.
The Maximum Power Point controller (MPP) ensures maximumefficiencyofthesolarmoduleatalltimes.This may increase the charging rate up to 50%.
MPP-Charge Controllers for Wind Power Stations
More than 100% increase of charge current with •MPP Controllers, through optimized dimensioning of the wind generator station.Optimal adaptation of battery and wind generator •at varying windspeeds.Complete solution with the combination of all neces-•sary system components, like low voltage disconnect, load resistor connection, 3 phase rectifyer.
windMax250 Wind generator voltage Ugenmax=120Vac, Accu system voltage 12V/24V, Accu charging current 8A, IP40 with RS232
windMax500 Wind generator voltage Ugenmax=120Vac, Accu system voltage 12V/24/48V, Charging current 20A, IP65, optional with Display and RS232
windMax1000 Wind generator voltage Ugenmax=120Vac, Accu system voltage 12V/24/48V, Charging current 40A, IP55, optional with Display and RS232
windMax1500 Wind generator voltage Ugenmax=120Vac, Accu system voltage 12V/24/48V, Charging current 60A, IP54, optional with Display and RS232
windMax2000 Wind generator voltage Ugenmax=120Vac, Accu system voltage 12V/24/48V, Charging current 80A, IP54, optional with Display and RS232
windMax2500 Wind generator voltage Ugenmax=120Vac, Accu system voltage 12V/24/48V, Charging current 100A, IP54, optional with Display and RS232
MPP-Wind Power Controller
Accu
Wind Generator
Load ResistorTotal
Discharge Protection
DC-Converterand
MPP-Controlling
Dump Load Switch
3 PhaseRecti�er
Charge-Controlling
Consumer
windMax500
windMax250
Schams-Electronic GmbHPeter Schwarz
Peter SchwarzRaiffeisenstr.4D-92367 PilsachTel: 0049-(0)9181-405554Fax: 0049-(0)9181-510456Mobil: 0049-(0)177-3097686Email: [email protected]: www.schams-solar.de
Additional Features of the Charge Controller
With our integrated DC-Converter it is possible •to transform solar voltage from 150V and wind generator voltage from 170V to a selectable bat-tery system voltage level.Due to our master-slave technique we can cus-•tomize the chargers. We offer controllers from 30W to 5kW.15 years of experience guarantee an optimal ben-•efitofyoursolar/windgenerator.
Benefits of our Charge Controller:Optimal adaptation of battery and solar module with •varying intensity of sunshineNodeficitwiththeinfluenceoftemperatureontheso-•lar cells, for example falling below the battery voltage when solar modules become too hot.Prevention of total discharge of the battery with •dynamic increase of the solar power at low battery voltage.Cabling with easy cable cross-sections, due to the pos-•sibility to choose higher solar voltage (up to 150V).Approximately 5 to 50% additional solar power •especially at times when it is most needed - during periods of bad weather and when the battery has been discharged.Easy handling and universal applications as for ex-•ample total discharge protection and dimmer as well as morning and evening timer for solar lighting all in one device.
Powergain via Accuvoltage
0
20
40
60
80
11.0 11.5 12.0 12.5 13.0 13.5 14.0
Ubat [V]
Ga
in [
%]
-10°C 0°C 20°C 50°C
This chart shows the increase of power gain through our MPP solar charge controllers with decreasing battery voltage. In addition, the diagram shows the influenceofthetemperatureofthesolarmodule.
Up to 50% More Solar Power through MPP-Controlling!
MPP-Solar Charge ControllerSMR100dt MPP-Solar Charge Controller for 12V accu
systems, accu charging current 8A, IP40 with Dimmer and 2 timers, Max. Solar voltage 25V
SMR250dt MPP-Solar Charge Controller for 12V and 24V accu systems, accu charging current 10A, IP40 with Dimmer and 2 timers, Max. Solar voltage 70V
SMR500 MPP-Solar Charge Controller for 12V/24V and 48V accu systems, 20A, IP65, optional with Display and RS232-Interface
SMR1000 MPP-Solar Charge Controller for 12V/24V and 48V accu systems, 40A, IP55, optional with Display and RS232-Interface
SMR1500 MPP-Solar Charge Controller for 12V/24V and 48V accu systems, 60A, IP54, optional with Display and RS232-Interface
SMR2000 MPP-Solar Charge Controller for 12V/24V and 48V accu systems, 80A, IP54, optional with Display and RS232-Interface
SMR2500 MPP-Solar Charge Controller for 12V/24V and 48V accu systems, 100A, IP54, optional with Display and RS232-Interface
SMR500 MPP Solar Charge Controller for 12V/24V and 48V
accu systems, 20A, IP65, optional with Display and RS232
SMR1000 MPP Solar Charge Controller for 12V/24V and
48V accu systems, 40A, IP55, optional with Display and
RS232-Interface
Accu
Consumer
Solar Module
DC-Converterand
MPP-Controlling
Dawn Switch
ChargeController
TotalDischargeProtection
Eveningand
Morning-timer
Accu
Consumer
Solar Module
Charge Controller and
BatteryManagement
TotalDischargeProtection
DC-Converterand
MPP-Controller
SMR250dt MPP Solar Charge Controller for 12V/24V accu systems, 10A, IP40
MPP Solar Charge Controller for Solar Lighting