Water-Cooled Series R (TM) - China

Job Information

Job01

Tag CRTHD-1 Compressor configuration E3 Compressor

Evaporator configuration G2 EvaporatorQuantity 1

Condenser configuration G1 Condenser

Product Version 1.8

Unit Information

Capacity Efficiency 0.686 kW/ton349.40 tons

NPLV Refrigerant charge (HFC-134a) 318 kg0.165 kW/kW

Pressure vessel code

Refrigerant isolation valvesRefrigeration isolation valves

Oil cooler With oil cooler

Operating weights include refrigerant, oil, and water charges.

Sound pressure measured in accordance with AHRI Standard 575-94.

Evaporator Information

Evap leaving temp 2.00 C Evap flow rate 59.72 L/s

Evap entering temp 7.00 C Evap pressure drop 6498.51 mm H2O

Minimum evap flow rate 31.04 L/s Evap fouling factor 0.00010 hr-sq ft-deg F/Btu

Number of evaporator passes 4 pass -3.61 CEvap fluid freeze point

Evap fluid type Ethylene Glycol Evap fluid concentration 10.00 %

Condenser Information

Cond entering temp 30.00 C Cond flow rate 88.33 L/s

Cond leaving temp 34.00 C Cond pressure drop 7047.68 mm H2O

Number of cond passes 2 pass condenser Cond fouling factor 0.00025 hr-sq ft-deg F/Btu

Cond fluid concentration 0.00 %Cond fluid type Water

Condenser tube type Enhanced fin - copper

Electrical Information

Unit voltage 415 Volt 3 phase Unit hertz 50 Hertz

Unit power 239.70 kW Starter type Wye-delta closed transition starter

Maximum overcurrent protection 857.30 AMinimum circuit ampacity 476.30 A

Starter expected inrush 776.00 A Motor locked rotor amps 2515.00 A

381.00 ARun load amps

This unit complies with the efficiency requirements of ASHRAE Standard 90.1-1999

Performance for above conditions is rated in accordance with AHRI Standard 550/590. The

following are outside the scope of AHRI Standard 550/590: Glycol, 50 Hz units below 200

tons.

Page 1 of 2

6/27/2011 Product Version 1.8

Water-Cooled Series R (TM) - China

Job Information

Job01

Tag CRTHD-2 Compressor configuration E3 Compressor

Evaporator configuration G2 EvaporatorQuantity 1

Condenser configuration G1 Condenser

Product Version 1.8

Unit Information

Capacity Efficiency 0.616 kW/ton392.90 tons

NPLV Refrigerant charge (HFC-134a) 318 kg0.146 kW/kW

Pressure vessel code

Refrigerant isolation valvesRefrigeration isolation valves

Oil cooler Without oil cooler

Operating weights include refrigerant, oil, and water charges.

Sound pressure measured in accordance with AHRI Standard 575-94.

Evaporator Information

Evap leaving temp 5.00 C Evap flow rate 65.74 L/s

Evap entering temp 10.00 C Evap pressure drop 7261.24 mm H2O

Minimum evap flow rate 25.93 L/s Evap fouling factor 0.00010 hr-sq ft-deg F/Btu

Number of evaporator passes 4 pass 0.00 CEvap fluid freeze point

Evap fluid type Water Evap fluid concentration 0.00 %

Condenser Information

Cond entering temp 30.00 C Cond flow rate 97.65 L/s

Cond leaving temp 34.00 C Cond pressure drop 8451.11 mm H2O

Number of cond passes 2 pass condenser Cond fouling factor 0.00025 hr-sq ft-deg F/Btu

Cond fluid concentration 0.00 %Cond fluid type Water

Condenser tube type Enhanced fin - copper

Electrical Information

Unit voltage 415 Volt 3 phase Unit hertz 50 Hertz

Unit power 242.00 kW Starter type Wye-delta closed transition starter

Maximum overcurrent protection 865.30 AMinimum circuit ampacity 480.70 A

Starter expected inrush 776.00 A Motor locked rotor amps 2515.00 A

384.60 ARun load amps

This unit complies with the efficiency requirements of ASHRAE Standard 90.1-1999

Certified in accordance with the AHRI Water-Chilling Packages using the Vapor

Compression Cycle Certification Program, which is based on AHRI Standard 550/590.

Page 2 of 2

6/27/2011 Product Version 1.8