week 12 11/13 – 11/14. learning targets: 1. apply geometric and dimension constraints to design...
Post on 30-Dec-2015
214 Views
Preview:
TRANSCRIPT
STEM AGENDASWeek 12
11/13 – 11/14
AGENDA 11/13Learning Targets:
1. Apply geometric and dimension constraints to design 3D-modeled parts.
2. Assemble the product using a modeling program.
To Do Today1. Discuss Sketch Plane Cube dimension
drawings2. FIX Sketch Plane Cube dimension DrawingsBy end of period –
• Fix Sketch Plane Cube (DUE BY 11/14)• Mallet Head/Handle and Assembly
If finished with Pegboard Project Continue Hydraulic Arm
SKETCH PLANE CUBE DIMENSION DRAWINGS If the dimension is highlighted in: PINK – Dimension Needed (good!) YELLOW – Dimension Not Needed GREEN – Duplicate Dimension (Not
needed)
If the dimension is CIRCLED in yellow there is a better place to put it (you have broken a rule for dimensioning that you didn’t need to).
LINES highlighted in yellow show placement errors.
AGENDA 11/14Learning Targets:
1. Apply geometric and dimension constraints to design 3D-modeled parts.
2. Assemble the product using a modeling program.
To Do Today1. Some Classes: Finish Sketch Plane Cube
Fix Sketch Plane Cube (DUE BY end of period)
2. Work on/Finish Pegboard Toy Mallet Head/Handle and Assembly FINAL ASSEMBLY (DUE BY FRIDAY!)
If finished Continue Hydraulic Arm
TOMORROW 11/15
Guest Speaker ExpectationsRespectful
No talking during presentation Raise your hand to speak
Excellence All REBS!
Be Responsible Be on time Come in quietly and sit down, ready to listen
Safe Sitting in chair with 4 on the floor
TOMORROW 11/16Learning Targets:
1. Apply geometric and dimension constraints to design 3D-modeled parts.
2. Assemble the product using a modeling program.
To Do Today1. Work on/Finish Pegboard Toy
Mallet Head/Handle and Assembly FINAL ASSEMBLY
8th GRADE: DUE BY END OF PERIOD (TODAY)! 7th GRADE: DUE BY END OF PERIOD ON
MONDAY!
If finished Continue Hydraulic Arm
top related